[PATCH] ARM: fix broken hibernation

Russell King rmk+kernel at arm.linux.org.uk
Wed Apr 1 08:45:56 PDT 2015


Normally, when a CPU wants to clear a cache line to zero in the external
L2 cache, it would generate bus cycles to write each word as it would do
with any other data access.

However, a Cortex A9 connected to a L2C-310 has a specific feature where
the CPU can detect this operation, and signal that it wants to zero an
entire cache line.  This feature, known as Full Line of Zeros (FLZ),
involves a non-standard AXI signalling mechanism which only the L2C-310
can properly interpret.

There are separate enable bits in both the L2C-310 and the Cortex A9 -
the L2C-310 needs to be enabled and have the FLZ enable bit set in the
auxiliary control register before the Cortex A9 has this feature
enabled.

Unfortunately, the suspend code was not respecting this - it's not
obvious from the code:

swsusp_arch_suspend()
 cpu_suspend() /* saves the Cortex A9 auxiliary control register */
  arch_save_image()
  soft_restart() /* turns off FLZ in Cortex A9, and disables L2C */
   cpu_resume() /* restores the Cortex A9 registers, inc auxcr */

At this point, we end up with the L2C disabled, but the Cortex A9 with
FLZ enabled - which means any memset() or zeroing of a full cache line
will fail to take effect.

A similar issue exists in the resume path, but it's slightly more
complex:

swsusp_arch_suspend()
 cpu_suspend() /* saves the Cortex A9 auxiliary control register */
  arch_save_image() /* image with A9 auxcr saved */
...
swsusp_arch_resume()
 call_with_stack()
  arch_restore_image() /* restores image with A9 auxcr saved above */
  soft_restart() /* turns off FLZ in Cortex A9, and disables L2C */
   cpu_resume() /* restores the Cortex A9 registers, inc auxcr */

Again, here we end up with the L2C disabled, but Cortex A9 FLZ enabled.

There's no need to turn off the L2C in either of these two paths; there
are benefits from not doing so - for example, the page copies will be
faster with the L2C enabled.

Hence, fix this by providing a variant of soft_restart() which can be
used without turning the L2 cache controller off, and use it in both
of these paths to keep the L2C enabled across the respective resume
transitions.

Fixes: 8ef418c7178f ("ARM: l2c: trial at enabling some Cortex-A9 optimisations")
Reported-by: xobs <-- please give me your preferred email for this!
Signed-off-by: Russell King <rmk+kernel at arm.linux.org.uk>
---
 arch/arm/kernel/hibernate.c |  5 +++--
 arch/arm/kernel/process.c   | 10 ++++++++--
 arch/arm/kernel/reboot.h    |  6 ++++++
 3 files changed, 17 insertions(+), 4 deletions(-)
 create mode 100644 arch/arm/kernel/reboot.h

diff --git a/arch/arm/kernel/hibernate.c b/arch/arm/kernel/hibernate.c
index c4cc50e58c13..cfb354ff2a60 100644
--- a/arch/arm/kernel/hibernate.c
+++ b/arch/arm/kernel/hibernate.c
@@ -22,6 +22,7 @@
 #include <asm/suspend.h>
 #include <asm/memory.h>
 #include <asm/sections.h>
+#include "reboot.h"
 
 int pfn_is_nosave(unsigned long pfn)
 {
@@ -61,7 +62,7 @@ static int notrace arch_save_image(unsigned long unused)
 
 	ret = swsusp_save();
 	if (ret == 0)
-		soft_restart(virt_to_phys(cpu_resume));
+		_soft_restart(virt_to_phys(cpu_resume), false);
 	return ret;
 }
 
@@ -86,7 +87,7 @@ static void notrace arch_restore_image(void *unused)
 	for (pbe = restore_pblist; pbe; pbe = pbe->next)
 		copy_page(pbe->orig_address, pbe->address);
 
-	soft_restart(virt_to_phys(cpu_resume));
+	_soft_restart(virt_to_phys(cpu_resume), false);
 }
 
 static u64 resume_stack[PAGE_SIZE/2/sizeof(u64)] __nosavedata;
diff --git a/arch/arm/kernel/process.c b/arch/arm/kernel/process.c
index c50fe212fd89..d14d38b860f8 100644
--- a/arch/arm/kernel/process.c
+++ b/arch/arm/kernel/process.c
@@ -42,6 +42,7 @@
 #include <asm/mach/time.h>
 #include <asm/tls.h>
 #include <asm/vdso.h>
+#include "reboot.h"
 
 #ifdef CONFIG_CC_STACKPROTECTOR
 #include <linux/stackprotector.h>
@@ -96,7 +97,7 @@ static void __soft_restart(void *addr)
 	BUG();
 }
 
-void soft_restart(unsigned long addr)
+void _soft_restart(unsigned long addr, bool disable_l2)
 {
 	u64 *stack = soft_restart_stack + ARRAY_SIZE(soft_restart_stack);
 
@@ -105,7 +106,7 @@ void soft_restart(unsigned long addr)
 	local_fiq_disable();
 
 	/* Disable the L2 if we're the last man standing. */
-	if (num_online_cpus() == 1)
+	if (disable_l2)
 		outer_disable();
 
 	/* Change to the new stack and continue with the reset. */
@@ -115,6 +116,11 @@ void soft_restart(unsigned long addr)
 	BUG();
 }
 
+void soft_restart(unsigned long addr)
+{
+	_soft_restart(addr, num_online_cpus() == 1);
+}
+
 /*
  * Function pointers to optional machine specific functions
  */
diff --git a/arch/arm/kernel/reboot.h b/arch/arm/kernel/reboot.h
new file mode 100644
index 000000000000..c87f05816d6b
--- /dev/null
+++ b/arch/arm/kernel/reboot.h
@@ -0,0 +1,6 @@
+#ifndef REBOOT_H
+#define REBOOT_H
+
+extern void _soft_restart(unsigned long addr, bool disable_l2);
+
+#endif
-- 
1.8.3.1




More information about the linux-arm-kernel mailing list