[PATCH 4/4] ARM: DT: apq8064: Add SATA controller support.

[Srinivas Kandagatla]

On 29/09/14 23:20, Stephen Boyd wrote:
> On 09/29/14 02:15, Srinivas Kandagatla wrote:
>> @@ -396,6 +407,35 @@
>>   			usb-phy		= <&usb4_phy>;
>>   		};
>>
>> +		sata_phy0:sata-phy at 1b400000{
>
> add some spaces here?
Will fix this in next version.
>
>> +			compatible	= "qcom,apq8064-sata-phy";
>> +			reg		= <0x1b400000 0x200>;
>> +			reg-names	= "phy_mem";
>> +			clocks		= <&gcc SATA_PHY_CFG_CLK>;
>> +			clock-names = "cfg";
>> +			#phy-cells = <0>;
>
> These two lost the pretty tabs.
>
Will fix this in next version.
>> +		};
>> +
>> +		sata0: sata at 29000000 {
>> +			compatible	= "generic-ahci";
>> +			reg		= <0x29000000 0x180>;
>> +			interrupts	= <0 209 0>;
>
> Sorry I'm nitpicking but it annoys me. Either align it all or don't
> align it.
I Will fix this in next version.

thanks,
srini
>
>> +			clocks = <&gcc SFAB_SATA_S_H_CLK>, <&gcc SATA_H_CLK>,
>> +				 <&gcc SATA_A_CLK>, <&gcc SATA_RXOOB_CLK>,
>> +				 <&gcc SATA_PMALIVE_CLK>;
>> +
>> +			clock-names = "slave_iface", "iface",
>> +				      "bus", "rxoob",
>> +				      "core_pmalive";
>> +			assigned-clocks = <&gcc SATA_RXOOB_CLK>,
>> +						<&gcc SATA_PMALIVE_CLK>;
>> +			assigned-clock-rates = <100000000>, <100000000>;
>> +
>> +			phys  = <&sata_phy0>;
>> +			phy-names = "sata-phy";
>> +			target-supply = <&pm8921_s4>;
>> +		};
>> +
>>   		/* Temporary fixed regulator */
>>   		vsdcc_fixed: vsdcc-regulator {
>>   			compatible = "regulator-fixed";
>
>