[PATCH v2 0/6] Add initial support for Broadcom Cygnus SoC

[Scott Branden]

Hi Matt/Christian (and others),

We would like to move forward in getting our base Cygnus support into 
the mainline kernel.  From there we will be able to contribute 
additional drivers.

Is somebody willing to accept this pull request to get this patchset 
accepted by the open source community?

Regards,
  Scott


On 14-09-23 02:17 PM, Jonathan Richardson wrote:
> Hi,
>
> This patchset contains initial support for Broadcom's Cygnus SoC based on our
> iProc architecture. Initial support is minimal and includes just the mach
> platform code, clock driver, and a basic device tree configuration. Peripheral
> drivers will be submitted soon, as will device tree configurations for other
> Cygnus board variants.
>
> Changes from v1:
>   - Address code review comments as per previous responses.
>   - Copyright headers updated to remove Broadcom URL.
>   - mach platform code still contains hard coded adresses. These address are
>     the same for all Cygnus variants. Could you please provide guidance on where
>     they should go if you would still like them changed.
>
> Thanks,
> Jon
>
> Jonathan Richardson (6):
>    ARM: cygnus: Initial support for Broadcom Cygnus SoC
>    clk: Clock driver support for Broadcom Cygnus SoC
>    dt-bindings: Document Broadcom Cygnus SoC and clock driver
>    ARM: dts: Enable Broadcom Cygnus SoC
>    ARM: cygnus defconfig : Initial defconfig for Broadcom Cygnus SoC
>    MAINTAINERS: Entry for Cygnus/iproc arm architecture and clock
>      drivers
>
>   Documentation/devicetree/bindings/arm/cygnus.txt   |   12 +
>   .../devicetree/bindings/clock/clk-cygnus.txt       |  121 ++
>   .../devicetree/bindings/clock/clk-iproc.txt        |   48 +
>   MAINTAINERS                                        |   21 +
>   arch/arm/boot/dts/Makefile                         |    1 +
>   arch/arm/boot/dts/bcm-cygnus.dtsi                  |  349 ++++++
>   arch/arm/boot/dts/bcm911360_entphn.dts             |   22 +
>   arch/arm/configs/bcm_cygnus_defconfig              |  223 ++++
>   arch/arm/mach-bcm/Kconfig                          |   31 +
>   arch/arm/mach-bcm/Makefile                         |    3 +
>   arch/arm/mach-bcm/bcm_cygnus.c                     |  166 +++
>   drivers/clk/Makefile                               |    1 +
>   drivers/clk/bcm/Makefile                           |    2 +
>   drivers/clk/bcm/clk-cygnus.c                       | 1186 ++++++++++++++++++++
>   drivers/clk/bcm/clk-iproc.c                        |  451 ++++++++
>   15 files changed, 2637 insertions(+)
>   create mode 100644 Documentation/devicetree/bindings/arm/cygnus.txt
>   create mode 100644 Documentation/devicetree/bindings/clock/clk-cygnus.txt
>   create mode 100644 Documentation/devicetree/bindings/clock/clk-iproc.txt
>   create mode 100644 arch/arm/boot/dts/bcm-cygnus.dtsi
>   create mode 100644 arch/arm/boot/dts/bcm911360_entphn.dts
>   create mode 100644 arch/arm/configs/bcm_cygnus_defconfig
>   create mode 100644 arch/arm/mach-bcm/bcm_cygnus.c
>   create mode 100644 drivers/clk/bcm/clk-cygnus.c
>   create mode 100644 drivers/clk/bcm/clk-iproc.c
>