[PATCHv3] dmaengine: fsl-edma: fixup reg offset and hw S/G support in big-endian model

[Lothar Waßmann]

Hi,

Jingchang Lu wrote:
> The offset of all 8-/16-bit register in big-endian eDMA model are
s/register/registers/

> swapped in a 32-bit size opposite those in the little-endian model.
> 
> The hardware Scatter/Gather requires the subsequent TCDs in memory
> to be auto loaded should retain little endian independent of the
> register endian model, the dma engine will do the swap if need.
> 
> This patch also use regular assignment for tcd variables r/w
> instead of with io function previously that may not always be true.
> 
> Signed-off-by: Jingchang Lu <jingchang.lu at freescale.com>
> ---
> changes in v3:
>  use unsigned long instead of u32 in reg offset swap cast to avoid warning.
> 
> changes in v2:
>  simplify register offset swap calculation.
>  use regular assignment for tcd variables r/w instead of io function.
> 
>  drivers/dma/fsl-edma.c | 106 ++++++++++++++++++++++++++-----------------------
>  1 file changed, 57 insertions(+), 49 deletions(-)
> 
> diff --git a/drivers/dma/fsl-edma.c b/drivers/dma/fsl-edma.c
> index 3c5711d..9ca55ee 100644
> --- a/drivers/dma/fsl-edma.c
> +++ b/drivers/dma/fsl-edma.c
> @@ -177,16 +177,10 @@ struct fsl_edma_engine {
>  /*
>   * R/W functions for big- or little-endian registers
>   * the eDMA controller's endian is independent of the CPU core's endian.
> + * for the big-endian IP module, the offset for 8-bit or 16-bit register
s/for/For/

> + * should also be swapped oposite to that in little-endian IP.
s/oposite/opposite/

[...]
> @@ -459,20 +460,27 @@ static void fill_tcd_params(struct fsl_edma_engine *edma,
>  	u16 csr = 0;
>  
>  	/*
> -	 * eDMA hardware SGs require the TCD parameters stored in memory
> -	 * the same endian as the eDMA module so that they can be loaded
> -	 * automatically by the engine
> +	 * eDMA hardware SGs requires the TCDs to be auto loaded
> +	 * in the little endian whenver the register endian model,
"in little endian whatever the register endian model"

> +	 * So we put the value in little endian in memory, waitting
s/waitting/waiting/

> +	 * for fsl_set_tcd_params doing the swap.
fsl_set_tcd_params()



Lothar Waßmann
-- 
___________________________________________________________

Ka-Ro electronics GmbH | Pascalstraße 22 | D - 52076 Aachen
Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10
Geschäftsführer: Matthias Kaussen
Handelsregistereintrag: Amtsgericht Aachen, HRB 4996

www.karo-electronics.de | info at karo-electronics.de
___________________________________________________________