[PATCH v3 0/4] Add picoPHY usb phy driver found on stih407 family SoC's

[Peter Griffin]

This series adds support for the picoPHY usb phy which is used by the usb2
and usb3 host controllers when controlling usb2/1.1 devices. It is found on
stih407 family SoC's from the consumer electronics devision of STMicroelectronics.

Changes since v2:
 - Remove .data and hardcode phy ops in devm_phy_create call (arndb)
 - Add COMPILE_TEST in kconfig (arndb)
 - Add depends on RESET_CONTROLLER in kconfig so COMPILE_TEST works
 - select GENERIC_PHY instead of depends on (Bartlomiej)

Changes since v1:
 - Remove reference to stih410 in dt documentation (kishon)
 - Fix alignment issue in dt example (kishon)
 - usbpicophy at f8 since you have a reg property (kishon)
 - Enable driver in multi_v7_defconfig

Peter Griffin (4):
  phy: phy-stih407-usb: Add usb picoPHY driver found on stih407 SoC
    family
  phy: phy-stih407-usb: Add dt documentation for USB picophy found on
    stih407 SoC family
  MAINTAINERS: Add phy-stih407-usb.c file to ARCH/STI architecture
  ARM: multi_v7_defconfig: Enable stih407 usb picophy

 .../devicetree/bindings/phy/phy-stih407-usb.txt    |  30 ++++
 MAINTAINERS                                        |   1 +
 arch/arm/configs/multi_v7_defconfig                |   1 +
 drivers/phy/Kconfig                                |   9 ++
 drivers/phy/Makefile                               |   2 +
 drivers/phy/phy-stih407-usb.c                      | 177 +++++++++++++++++++++
 6 files changed, 220 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/phy/phy-stih407-usb.txt
 create mode 100644 drivers/phy/phy-stih407-usb.c

-- 
1.9.1