[PATCH 1/5] ARM: dts: pbab01: move i2c pins and frequency configuration into pfla02

[Philipp Zabel]

Am Mittwoch, den 10.09.2014, 16:46 +0300 schrieb Dmitry Lavnikevich:
> Since pins and frequency are specific to module (pfla02), not base board
> (pbab02), it is better to be initialized in corresponding dts file.
> 
> Signed-off-by: Dmitry Lavnikevich <d.lavnikevich at sam-solutions.com>

I have seen boards use the GPIO_3/6 pads instead of EIM_D17/D18 for
I2C3, but the EIM_D17/D18 are indeed documented as "I2C1" pins at the
pfla02 connector level.

regards
Philipp