[PATCH v2 0/8] ARM: Berlin: Ethernet support

[Antoine Tenart]

Hi all,

This series introduce support for the Ethernet controller on Berlin SoCs,
using the existing pxa168 Ethernet driver. In order to do this, DT
support is added to the driver alongside some other modifications and
fixes.

Version 1 of this series was introducing a new Ethernet driver but thanks
to Sebastian's review it seems we can actually use the existing pxa168
Ethernet driver. This second version uses it.

This has been tested on a Berlin BG2Q DMP board.

Changes since v1:
	- removed custom Berlin Ethernet driver
	- used the pxa168 Ethernet driver instead
	- made modifications to the pxa168 driver (DT support, fixes)

Antoine Tenart (8):
  net: pxa168_eth: clean up
  net: pxa168_eth: add device tree support
  Documentation: bindings: net: add the Marvell PXA168 Ethernet
    controller
  net: pxa168_eth: fix Ethernet flow control status
  net: pxa168_eth: get and set the mac address on the Ethernet
    controller
  net: pxa168_eth: allow Berlin SoCs to use the pxa168_eth driver
  ARM: dts: berlin: add the Ethernet node
  ARM: dts: berlin: enable the Ethernet port on the BG2Q DMP

 .../devicetree/bindings/net/marvell-pxa168.txt     |  22 +++
 arch/arm/boot/dts/berlin2q-marvell-dmp.dts         |   4 +
 arch/arm/boot/dts/berlin2q.dtsi                    |   9 +
 drivers/net/ethernet/marvell/Kconfig               |   2 +-
 drivers/net/ethernet/marvell/pxa168_eth.c          | 207 +++++++++++++--------
 5 files changed, 165 insertions(+), 79 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/net/marvell-pxa168.txt

-- 
1.9.1