[PATCH RESEND v5 0/5] Add EHCI and OHCI drivers for STi SoC's

Peter Griffin peter.griffin at linaro.org
Fri Sep 5 10:23:44 PDT 2014


Hi,

As part of the RESEND I've rebased this series on top of 3.17-rc3. I believe all
feedback has been addressed.

The series was re-worked from v2 onwards to split out the ehci and ohci parts
into their own drivers / devices like most other ARM platforms based on
feedback from Arnd Bergmann (see here http://www.spinics.net/lists/linux-usb/msg111124.html. 

The ehci-platform & ohci-platform have been used as a basis for this in case we
wish to merge the drivers again in the future.

Changes since v4:
 - Ensure suspend / resume callbacks are wrapped in #ifdef CONFIG_PM_SLEEP as otherwise we
   will get linker 'unused function' warnings when this option is disabled.
 - Only declare and reference pm_ops struct if CONFIG_PM_SLEEP is enabled, this saves a few bytes

Changes since v3:
 - Make reset / power, clocks etc non optional dt options to simplify code
 - Get rid of non DT boot code left over from *hci-platform drivers
 - Remove DMA mask code
 - Remove pre_setup func ptr and configure ahb2st bus convertor in ehci_platform_reset
 - Unabstract and remove usb-st-common.c
 - Have one kconfig which enables both ehci-st & ohci-st drivers

Changes since v2:
 - Based on Arnd Berghman feedback, split out into 2 devices / drivers
 - Base drivers oh ehci-platform.c & ohci-platform.c with required extensions
   to allow possible re-merge in the furture.

Changes since v1:
 - Correct s/OCHI/OHCI/ spelling
 - Improve kconfig help message
 - Various formating / spelling nits identified by Lee Jones
 - Make driver depend on OF & remove node checks in code
 - Use devm_ioremap_resource
 - Remove unnecessary header files

Peter Griffin (5):
  usb: host: ehci-st: Add EHCI support for ST STB devices
  usb: host: ohci-st: Add OHCI driver support for ST STB devices
  usb: host: ehci-st: Add ehci-st devicetree bindings documentation
  usb: host: ohci-st: Add ohci-st devicetree bindings documentation
  MAINTAINERS: Add ehci-st.c and ohci-st.c to ARCH/STI architecture

 Documentation/devicetree/bindings/usb/ehci-st.txt |  39 +++
 Documentation/devicetree/bindings/usb/ohci-st.txt |  37 +++
 MAINTAINERS                                       |   2 +
 drivers/usb/host/Kconfig                          |   8 +
 drivers/usb/host/Makefile                         |   1 +
 drivers/usb/host/ehci-st.c                        | 365 ++++++++++++++++++++++
 drivers/usb/host/ohci-st.c                        | 339 ++++++++++++++++++++
 drivers/usb/host/usb-st-common.h                  |  31 ++
 8 files changed, 822 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/ehci-st.txt
 create mode 100644 Documentation/devicetree/bindings/usb/ohci-st.txt
 create mode 100644 drivers/usb/host/ehci-st.c
 create mode 100644 drivers/usb/host/ohci-st.c
 create mode 100644 drivers/usb/host/usb-st-common.h

-- 
1.9.1




More information about the linux-arm-kernel mailing list