[Linaro-acpi] [RFC PATCH for Juno 1/2] net: smsc911x add support for probing from ACPI

[Catalin Marinas]

On Mon, Sep 01, 2014 at 04:28:54PM +0100, Graeme Gregory wrote:
> On Mon, Sep 01, 2014 at 05:17:51PM +0200, Arnd Bergmann wrote:
> > On Monday 01 September 2014 23:06:00 Hanjun Guo wrote:
> > > +#ifdef CONFIG_ACPI
> > > +/* Configure some sensible defaults for ACPI mode */
> > > +static int smsc911x_probe_config_acpi(struct smsc911x_platform_config *config,
> > > +                                   acpi_handle *ahandle)
> > > +{
> > > +       if (!ahandle)
> > > +               return -ENOSYS;
> > > +
> > > +       config->phy_interface = PHY_INTERFACE_MODE_MII;
> > > 
> > 
> > Please remove the #ifdef and use 
> > 
> > 	if (!IS_ENABLED(CONFIG_ACPI) || !ahandle)
> > 
> > to check for ACPI support. This should result in the same object code
> > in all cases, but give better compile-time coverage when ACPI is
> > disabled.
> > 
> struct acpi_handle does not exist in the case !CONFIG_ACPI

Confused. Then how come smsc911x_drv_probe() has this line:

	acpi_handle *ahandle = ACPI_HANDLE(&pdev->dev);

without any #ifdef's.

-- 
Catalin