Setting cpu affinity for MSI-X on i.mx6 possible?

[Heiner Kallweit]

Thanks, Lucas.

It's interesting however that the igb driver claims it's using MSI-X.
Maybe the DW PCIE drivers offers MSI-X on the bus and just internally falls back to MSI?

Rgds, Heiner

[    4.165850] igb: Intel(R) Gigabit Ethernet Network Driver - version 5.2.15-k
[    4.172930] igb: Copyright (c) 2007-2014 Intel Corporation.
[    4.178638] igb 0000:01:00.0: enabling device (0140 -> 0142)
[    4.235789] igb 0000:01:00.0: added PHC on eth0
[    4.235793] igb 0000:01:00.0: Intel(R) Gigabit Ethernet Network Connection
[    4.235799] igb 0000:01:00.0: eth0: (PCIe:2.5Gb/s:Width x1) 00:01:c0:14:b1:58
[    4.235804] igb 0000:01:00.0: eth0: PBA No: FFFFFF-0FF
[    4.235810] igb 0000:01:00.0: Using MSI-X interrupts. 2 rx queue(s), 2 tx queue(s)


Am 27.10.2014 um 09:52 schrieb Lucas Stach:
> Hello Heiner,
> 
> Am Sonntag, den 26.10.2014, 19:05 +0100 schrieb Heiner Kallweit:
>> I use a mini pc with i.mx6 dual and Intel igb based nic (I211) connected via PCIE.
>> igb driver uses MSI-X and creates two rx/tx queue pairs. However the IRQs of all queues are handled by the same CPU.
>> Changing affinity is not possible. Obvious direct reason is that irq_chip PCI-MSI doesn't implement the callback
>> for setting cpu affinity.
>> I'd appreciate a hint whether this is a general limitation of the Cortex-A9 / GICv1 / Synopsys Designware
>> architecture or whether just a proper implementation is missing yet.
>>
>> Rgds, Heiner
> 
> The MSI controller on imx6 doesn't support MSI-X so igb falls back to
> regular MSI interrupts. Also all MSI interrupts are aggregated into a
> single GIC interrupt line. This means the best we could do is switch all
> PCIe MSI interrupts to some other CPU. Configuring the CPU affinity on a
> per interrupt basis is impossible on this hardware.
> 
> Regards,
> Lucas
>