[PATCHv0] arm: mvebu: enable rear eSATA ports of NETGEAR ReadyNAS 2120

[Andrew Lunn]

On Sat, Oct 25, 2014 at 05:32:42PM +0200, Arnaud Ebalard wrote:
> 
> NETGEAR ReadyNAS 2120 supports its four main SATA disks via 2
> Marvell 88SE9170 SATA controllers connected on the PCIe bus
> of the the SoC. The two eSATA ports available at the rear of
> the device are handled by the native SATA controller of the
> Armada XP SoC powering the NAS. This patch enables the SoC
> SATA controller in the .dts file to make those two rear ports
> available.
> 
> Signed-off-by: Arnaud Ebalard <arno at natisbad.org>

Acked-by: Andrew Lunn <andrew at lunn.ch>

> ---
>  arch/arm/boot/dts/armada-xp-netgear-rn2120.dts | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/armada-xp-netgear-rn2120.dts b/arch/arm/boot/dts/armada-xp-netgear-rn2120.dts
> index 7d8f32873e82..e3a8c456bb84 100644
> --- a/arch/arm/boot/dts/armada-xp-netgear-rn2120.dts
> +++ b/arch/arm/boot/dts/armada-xp-netgear-rn2120.dts
> @@ -137,6 +137,12 @@
>  				};
>  			};
>  
> +			/* Two rear eSATA ports */
> +			sata at a0000 {
> +				nr-ports = <2>;
> +				status = "okay";
> +			};
> +
>  			serial at 12000 {
>  				status = "okay";
>  			};
> -- 
> 2.1.1
>