[PATCHv0 1/2] arm: mvebu: fix LED color in NETGEAR ReadyNAS 102 .dts file

Andrew Lunn andrew at lunn.ch
Fri Oct 24 14:20:38 PDT 2014


On Fri, Oct 24, 2014 at 11:22:01PM +0200, Arnaud Ebalard wrote:
> 
> When writing initial .dts file for NETGEAR ReadyNAS 102, I put the wrong color
> for backup and SATA leds (green instead of blue for all three).
> 
> Reported-by: Johan Kristell <johan.kristell at gmail.com>
> Signed-off-by: Arnaud Ebalard <arno at natisbad.org>

Acked-by: Andrew Lunn <andrew at lunn.ch>

	  Andrew

> ---
>  arch/arm/boot/dts/armada-370-netgear-rn102.dts | 12 ++++++------
>  1 file changed, 6 insertions(+), 6 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/armada-370-netgear-rn102.dts b/arch/arm/boot/dts/armada-370-netgear-rn102.dts
> index 3aebd93cc33c..f79579bdf8fe 100644
> --- a/arch/arm/boot/dts/armada-370-netgear-rn102.dts
> +++ b/arch/arm/boot/dts/armada-370-netgear-rn102.dts
> @@ -204,20 +204,20 @@
>  			default-state = "keep";
>  		};
>  
> -		green-sata1-led {
> -			label = "rn102:green:sata1";
> +		blue-sata1-led {
> +			label = "rn102:blue:sata1";
>  			gpios = <&gpio0 15 GPIO_ACTIVE_LOW>;
>  			default-state = "on";
>  		};
>  
> -		green-sata2-led {
> -			label = "rn102:green:sata2";
> +		blue-sata2-led {
> +			label = "rn102:blue:sata2";
>  			gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
>  			default-state = "on";
>  		};
>  
> -		green-backup-led {
> -			label = "rn102:green:backup";
> +		blue-backup-led {
> +			label = "rn102:blue:backup";
>  			gpios = <&gpio1 24 GPIO_ACTIVE_LOW>;
>  			default-state = "on";
>  		};
> -- 
> 2.1.1
> 
> 



More information about the linux-arm-kernel mailing list