[PATCH v12 09/15] arm: Remove DEBUG_LL_UART_NONE

[Daniel Thompson]

Only a very small handful of platforms support DEBUG_LL_UART_NONE but it
lurks in the menus of every single platform config ready to break the
build. This is an especial problem for defconfig/oldconfig since it is
often selected by default.

This patch solves the problem by removing this option. Any platforms
still depending upon this option must be migrated.

Signed-off-by: Daniel Thompson <daniel.thompson at linaro.org>
Cc: Russell King <linux at arm.linux.org.uk>
---
 arch/arm/Kconfig.debug | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index 295428d..5881c94 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -909,15 +909,6 @@ choice
 		  This option selects UART0 on VIA/Wondermedia System-on-a-chip
 		  devices, including VT8500, WM8505, WM8650 and WM8850.
 
-	config DEBUG_LL_UART_NONE
-		bool "No low-level debugging UART"
-		depends on !ARCH_MULTIPLATFORM
-		help
-		  Say Y here if your platform doesn't provide a UART option
-		  above. This relies on your platform choosing the right UART
-		  definition internally in order for low-level debugging to
-		  work.
-
 	config DEBUG_ICEDCC
 		bool "Kernel low-level debugging via EmbeddedICE DCC channel"
 		help
-- 
1.9.3