[PATCH v2 1/4] pinctrl: rockchip: Set wake_enabled

[Doug Anderson]

The rockchip pinctrl driver uses irq_gc_set_wake() but doesn't setup
the .wake_enabled member.  That means that we can never actually use a
pin for wakeup.  When "irq_set_irq_wake()" tries to call through it
will always get a failure from set_irq_wake_real() and will then set
wake_depth to 0.  Assuming you can resume you'll later get an error
message about "Unbalanced IRQ x wake disable".

Signed-off-by: Doug Anderson <dianders at chromium.org>
Tested-by: Chris Zhong <zyw at rock-chips.com>
---
Changes in v2: None

 drivers/pinctrl/pinctrl-rockchip.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/pinctrl/pinctrl-rockchip.c b/drivers/pinctrl/pinctrl-rockchip.c
index 016f457..230d8f3 100644
--- a/drivers/pinctrl/pinctrl-rockchip.c
+++ b/drivers/pinctrl/pinctrl-rockchip.c
@@ -1563,6 +1563,7 @@ static int rockchip_interrupts_register(struct platform_device *pdev,
 		gc->chip_types[0].chip.irq_unmask = irq_gc_mask_set_bit;
 		gc->chip_types[0].chip.irq_set_wake = irq_gc_set_wake;
 		gc->chip_types[0].chip.irq_set_type = rockchip_irq_set_type;
+		gc->wake_enabled = IRQ_MSK(bank->nr_pins);
 
 		irq_set_handler_data(bank->irq, bank);
 		irq_set_chained_handler(bank->irq, rockchip_irq_demux);
-- 
2.1.0.rc2.206.gedb03e5