[RFC Patch 1/4] mfd: AXP20x: Add power supply bindings documentation

[Bruno Prémont]

---
Note: the OCV values seem to have some defaults build into the
PMIC though may need adjustment if the used battery has a different
open circuit voltage curve.
As far as understood (these values are set in vendor driver but not
mentioned in chip documentation) they represent charge percentage
for some predefined voltages.

If prefixing these values with "x-power," is preferred the following
patch should becomes a dependency:
  http://lists.infradead.org/pipermail/linux-arm-kernel/2014-June/267606.html
and users in patch 2/4, 4/4 need adjusting.


 Documentation/devicetree/bindings/mfd/axp20x.txt |   20 +
 1 files changed, 20 insertions(+), 0 deletion(-)

diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt
index cc9e01b..8ea681c 100644
--- a/Documentation/devicetree/bindings/mfd/axp20x.txt
+++ b/Documentation/devicetree/bindings/mfd/axp20x.txt
@@ -28,6 +28,20 @@ Required properties:
 		      (range: 750-1875). Default: 1.5MHz
 
 Optional properties for DCDCs:
+- backup: Settings for backup/RTC battery charger
+	  (Voltage in µV, current in µA)
+	  If not present, charger will be left untouched
+- battery.ocv: OCV capacity curve points (16 data values)
+- battery.resistance: internal battery resistance in mΩ
+                      (defaults to 100mΩ)
+- battery.capacity: Battery capacity in mAh
+		    If this attribute is missing, charger will be disabled
+		    unless there is a battery connected.
+- battery.temp_sensor: Description of temperautre sensor, 3 values
+		       - driver current (20µA, 40µA, 60µA or 80µA)
+		       - low temperature warning level (in µV)
+		       - high temperature warning level (in µV)
+		       If missing, temperature sensor gets disabled
 - x-powers,dcdc-workmode: 1 for PWM mode, 0 for AUTO mode
 			  Default: AUTO mode
 
@@ -49,6 +63,12 @@ axp209: pmic at 34 {
 	ldo3in-supply = <&axp_ipsout_reg>;
 	ldo5in-supply = <&axp_ipsout_reg>;
 
+	backup = <3000000 200>;
+	battery.ocv = <0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0>;
+	battery.resistance = <0>;
+	battery.capacity = <2000>;
+	battery.temp_sensor = <20 1000000 4000000>;
+
 	regulators {
 		x-powers,dcdc-freq = <1500>;
 
-- 
2.0.4