[PATCH v2 00/11] ARM: dts: zynq: Prepare Parallella

Olof Johansson olof at lixom.net
Fri Oct 17 21:28:02 PDT 2014


Hi Andreas,

On Thu, Jul 24, 2014 at 4:00 PM, Andreas Färber <afaerber at suse.de> wrote:
> Hello,
>
> This patch series adds an initial device tree for the Parallella board.
> UART, SD card, Ethernet are enabled.
> Not yet enabled are HDMI, QSPI flash and 2x USB.

Andreas (Olofsson) kindly sent me a board, and I added it to the boot
farm today, it'll be included in boot reports from here on.

I did a test run with yesterday's -next It looks like networking isn't
working there at the moment, clock related. Same happens with 3.17 and
latest mainline, config multi_v7_defconfig:

[WARN] [    7.943648] macb e000b000.ethernet eth0: unable to generate
target frequency: 125000000 Hz
[WARN] [   10.948681] macb e000b000.ethernet eth0: unable to generate
target frequency: 125000000 Hz

Full boot log at:

http://arm-soc.lixom.net/bootlogs/misc/next-20141017/parallella-arm-multi_v7_defconfig.html

I'll be happy to try things, but I'm a bit short on cycles to debug
myself. Should hopefully be easy to reproduce.


-Olof



More information about the linux-arm-kernel mailing list