[PATCH v2] mmc: dw_mmc: Reset DMA before enabling IDMAC

[Sonny Rao]

We've already got a reset of DMA after it's done.  Add one before we
start DMA too.  This fixes a data corruption on Rockchip SoCs which
will get bad data when doing a DMA transfer after doing a PIO transfer.

We tested this on an Exynos 5800 with HS200 and didn't notice any
difference in sequential read throughput.

Signed-off-by: Sonny Rao <sonnyrao at chromium.org>
Signed-off-by: Doug Anderson <dianders at chromium.org>
Tested-by: Doug Anderson <dianders at chromium.org>
---
 drivers/mmc/host/dw_mmc.c | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
index 69f0cc6..ca67f69 100644
--- a/drivers/mmc/host/dw_mmc.c
+++ b/drivers/mmc/host/dw_mmc.c
@@ -83,6 +83,7 @@ struct idmac_desc {
 #endif /* CONFIG_MMC_DW_IDMAC */
 
 static bool dw_mci_reset(struct dw_mci *host);
+static bool dw_mci_ctrl_reset(struct dw_mci *host, u32 reset);
 
 #if defined(CONFIG_DEBUG_FS)
 static int dw_mci_req_show(struct seq_file *s, void *v)
@@ -448,6 +449,10 @@ static void dw_mci_idmac_start_dma(struct dw_mci *host, unsigned int sg_len)
 
 	dw_mci_translate_sglist(host, host->data, sg_len);
 
+	/* Make sure to reset DMA in case we did PIO before this */
+	dw_mci_ctrl_reset(host, SDMMC_CTRL_DMA_RESET);
+	dw_mci_idmac_reset(host);
+
 	/* Select IDMAC interface */
 	temp = mci_readl(host, CTRL);
 	temp |= SDMMC_CTRL_USE_IDMAC;
-- 
2.1.2