[PATCH v5 07/11] mmc: sdio: Convert to dev_pm_domain_attach|detach()

[Aaron Lu]

On 10/02/2014 08:27 AM, Dmitry Torokhov wrote:
> Hi Ulf,
> 
> On Fri, Sep 19, 2014 at 08:27:40PM +0200, Ulf Hansson wrote:
>> Previously only the ACPI PM domain was supported by the sdio bus.
>>
>> Let's convert to the common attach/detach functions for PM domains,
>> which currently means we are extending the support to include the
>> generic PM domain as well.
>>
>> Cc: linux-mmc at vger.kernel.org
>> Signed-off-by: Ulf Hansson <ulf.hansson at linaro.org>
>> Reviewed-by: Kevin Hilman <khilman at linaro.org>
>> ---
>>  drivers/mmc/core/sdio_bus.c | 4 ++--
>>  1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/mmc/core/sdio_bus.c b/drivers/mmc/core/sdio_bus.c
>> index 4fa8fef9..1df0fc6 100644
>> --- a/drivers/mmc/core/sdio_bus.c
>> +++ b/drivers/mmc/core/sdio_bus.c
>> @@ -315,7 +315,7 @@ int sdio_add_func(struct sdio_func *func)
>>  	ret = device_add(&func->dev);
>>  	if (ret == 0) {
>>  		sdio_func_set_present(func);
>> -		acpi_dev_pm_attach(&func->dev, false);
>> +		dev_pm_domain_attach(&func->dev, false);
> 
> Admittedly it is not brought in by your change, but I am a bit worried
> about this code. In all other busses we attach power domain to a device
> before probing it (and detach if probe fails). Why here we only attach
> it to power domain after adding the device to the bus? If driver for the
> function has already been loaded the probe() would run without device
> being attached to a power domain...

Sorry for replying late...

I see your concern, but it should be safe here. The dev_pm_domain_attach
does primarily two things(for ACPI based system): assign the pm_domian
field so that later system and runtime PM transitions we have proper
callbacks for this device; power on the device if needed.

I was using Broadcom BCM43241 SDIO wifi card when developing the code,
it doesn't need the pm_domain set in its probe function and since the
SDIO wifi card is powered on after system boot, no power on is needed
either. That's why I added the attach function after device_add to save
a little code(detach if probe fails).

Feel free to change the sequence if the current one is a bad one, I'm OK
with either case.

> 
> Adding Aaron as he's the author of the original change.

Thanks,
Aaron