[PATCH v2 3/3] ARM: dts: qcom: Add SDHC nodes for APQ8084 platform

[Bjorn Andersson]

On Tue, Sep 2, 2014 at 8:40 AM, Georgi Djakov <gdjakov at mm-sol.com> wrote:
> Enable support for the two SD host controllers on the APQ8084 platform
> by adding the required nodes to the DT files.
> On the IFC6540 board, the first controller is connected to the onboard
> eMMC and the second is connected to a micro-SD card slot.
>
> Signed-off-by: Georgi Djakov <gdjakov at mm-sol.com>

Hi Georgi,

This looks sane, but...

> ---
>  arch/arm/boot/dts/qcom-apq8084-ifc6540.dts |   11 +++++++++++
>  arch/arm/boot/dts/qcom-apq8084.dtsi        |   23 +++++++++++++++++++++++
>  2 files changed, 34 insertions(+)
>
> diff --git a/arch/arm/boot/dts/qcom-apq8084-ifc6540.dts b/arch/arm/boot/dts/qcom-apq8084-ifc6540.dts
> index e41cb8a..c9ff108 100644
> --- a/arch/arm/boot/dts/qcom-apq8084-ifc6540.dts
> +++ b/arch/arm/boot/dts/qcom-apq8084-ifc6540.dts
[..]
> +               sdhci at f98a4900 {
> +                       cd-gpios = <&tlmm 122 GPIO_ACTIVE_LOW>;
> +                       bus-width = <4>;

...why do you add this node and leave it disabled in the dts?

> +               };
>         };
>  };

Regards,
Bjorn