[PATCH v3 3/3] ARM: shmobile: henninger: enable HS-USB

[Sergei Shtylyov]

From: Yoshihiro Shimoda <yoshihiro.shimoda.uh at renesas.com>

Enable HS-USB device for the Henninger board, defining the GPIO that the driver
should check when probing (which is the ID output from MAX3355 OTG chip).

Note that there will be pinctrl-related error messages if both internal PCI
and HS-USB drivers are enabled but they should be just ignored.

Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh at renesas.com>
[Sergei: added pin function/group and prop, moved device node, fixed summary,
added changelog]
Signed-off-by: Sergei Shtylyov <sergei.shtylyov at cogentembedded.com>

---
Changes in version 2:
- added pinctrl-related properties;
- moved the HS-USB node to precede the USB PHY node;
- uppercased "arm" in the summary;
- added changelog.

 arch/arm/boot/dts/r8a7791-henninger.dts |    7 +++++++
 1 file changed, 7 insertions(+)

Index: renesas/arch/arm/boot/dts/r8a7791-henninger.dts
===================================================================
--- renesas.orig/arch/arm/boot/dts/r8a7791-henninger.dts
+++ renesas/arch/arm/boot/dts/r8a7791-henninger.dts
@@ -272,6 +272,13 @@
 	pinctrl-names = "default";
 };
 
+&hsusb {
+	status = "okay";
+	pinctrl-0 = <&usb0_pins>;
+	pinctrl-names = "default";
+	renesas,enable-gpio = <&gpio5 31 GPIO_ACTIVE_HIGH>;
+};
+
 &usbphy {
 	status = "okay";
 };