[PATCH] ARM: dts: fix MMC2 regulators for Exynos5420 Arndale Octa board

[Bartlomiej Zolnierkiewicz]

On Thursday, October 02, 2014 09:19:08 AM Doug Anderson wrote:
> Bartiomiej,
> 
> On Thu, Oct 2, 2014 at 9:10 AM, Bartlomiej Zolnierkiewicz
> <b.zolnierkie at samsung.com> wrote:
> > Regulators for MMC2 (SD card) are PVDD_TFLASH_2V8 (LDO19) for vmmc
> > and PVDD_APIO_MMCOFF_2V8 (LDO13) for vqmmc.  Currently the device
> > tree entry for MMC2 uses PVDD_PRE_1V8 (LDO10) for vmmc and vqmmc is
> > not specified.  Fix it.
> >
> > Without this patch:
> > - "mmc: dw_mmc: use mmc_regulator_get_supply to handle regulators"
> >   patch causes a SD card detection to fail
> > - "mmc: dw_mmc: Support voltage changes" patch causes a boot hang
> >
> > This patch fixes both above problems.
> >
> > Suggested-by: Doug Anderson <dianders at google.com>
> > Cc: Yuvaraj Kumar C D <yuvaraj.cd at samsung.com>
> > Cc: Ulf Hansson <ulf.hansson at linaro.org>
> > Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie at samsung.com>
> > Acked-by: Kyungmin Park <kyungmin.park at samsung.com>
> > ---
> >  arch/arm/boot/dts/exynos5420-arndale-octa.dts |    3 ++-
> >  1 file changed, 2 insertions(+), 1 deletion(-)
> >
> > Index: b/arch/arm/boot/dts/exynos5420-arndale-octa.dts
> > ===================================================================
> > --- a/arch/arm/boot/dts/exynos5420-arndale-octa.dts     2014-10-02 15:44:53.014826886 +0200
> > +++ b/arch/arm/boot/dts/exynos5420-arndale-octa.dts     2014-10-02 17:35:24.110600398 +0200
> > @@ -74,7 +74,8 @@
> >                 samsung,dw-mshc-ddr-timing = <1 2>;
> >                 pinctrl-names = "default";
> >                 pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_cd &sd2_bus4>;
> > -               vmmc-supply = <&ldo10_reg>;
> > +               vmmc-supply = <&ldo19_reg>;
> > +               vqmmc-supply = <&ldo13_reg>;
> 
> This looks right to me.  ...but I notice that ldo13 and ldo19 are not
> "always-on" in the DTS.  Are you sure card detect works for you if you
> eject your card and try to put it back in?
> 
> ...eventually the "always-on" won't be needed, but for now I think it is...

Card detection works fine without "always-on".

Best regards,
--
Bartlomiej Zolnierkiewicz
Samsung R&D Institute Poland
Samsung Electronics