[linux-sunxi] Re: [PATCH 4/4] simplefb: add clock handling code

[Thierry Reding]

On Wed, Oct 01, 2014 at 08:43:27PM +0200, Geert Uytterhoeven wrote:
> On Wed, Oct 1, 2014 at 7:17 PM, Mark Brown <broonie at kernel.org> wrote:
> >> Well, I don't think it should because it describes the same resources
> >> that the device tree node for the real device already describes. But
> >> perhaps this is one of the cases where duplication isn't all that bad?
> >
> > If we were worried about this wecould also do it by referring to
> > those nodes and saying "get all the resources these things need" rather
> > than duplicating the references (this might make it easier to work out
> > when the system is ready to hand off to the real drivers).
> 
> You can have a single node for both simplefb and the later "real" driver.
> DT describes the hardware, not the software ecosystem running on the
> hardware. Clock, regulators, etc. don't change from a hardware point of
> view.
> 
> If the firmware initialized a suitable graphics mode, it just has to add
> "linux,simplefb" to the compatible property (and perhaps a few other
> simplefb-specific properties).

Unfortunately I don't think that's going to work. Especially on ARM SoCs
there is no single node for a display device. The display device is
typically composed of several subdevices.

Thierry
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 819 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20141002/2d4f759b/attachment.sig>