[PATCH 4/4] ARM: sti: Provide DT nodes for SBC SSC[0..2]

[Lee Jones]

The Synchronous Serial Controller is used to provide SPI.

These are the ports which are located on the Stand-By Controller (SBC).

Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/boot/dts/stih407.dtsi | 31 +++++++++++++++++++++++++++++++
 1 file changed, 31 insertions(+)

diff --git a/arch/arm/boot/dts/stih407.dtsi b/arch/arm/boot/dts/stih407.dtsi
index 245aa31..cff106d 100644
--- a/arch/arm/boot/dts/stih407.dtsi
+++ b/arch/arm/boot/dts/stih407.dtsi
@@ -329,5 +329,36 @@
 
 			status = "disabled";
 		};
+
+		/* SBC SSC */
+		spi at 9540000 {
+			compatible = "st,comms-ssc-spi";
+			reg = <0x9540000 0x110>;
+			interrupts = <GIC_SPI 135 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&clk_sysin>;
+			clock-names = "ssc";
+
+			status = "disabled";
+		};
+
+		spi at 9541000 {
+			compatible = "st,comms-ssc-spi";
+			reg = <0x9541000 0x110>;
+			interrupts = <GIC_SPI 136 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&clk_sysin>;
+			clock-names = "ssc";
+
+			status = "disabled";
+		};
+
+		spi at 9542000 {
+			compatible = "st,comms-ssc-spi";
+			reg = <0x9542000 0x110>;
+			interrupts = <GIC_SPI 137 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&clk_sysin>;
+			clock-names = "ssc";
+
+			status = "disabled";
+		};
 	};
 };
-- 
1.9.1