[PATCH v2 2/2] of: support passing console options with stdout-path

[Andrew Lunn]

On Wed, Nov 26, 2014 at 09:07:33PM +0000, Grant Likely wrote:
> On Wed, Nov 26, 2014 at 6:30 PM, Andrew Lunn <andrew at lunn.ch> wrote:
> > On Wed, Nov 26, 2014 at 05:40:40PM +0000, Leif Lindholm wrote:
> >> Support specifying console options (like with console=ttyXN,<options>)
> >> by appending them to the stdout-path property after a separating ':'.
> >>
> >> Example:
> >>         stdout-path = "uart0:115200";
> >
> > Hi Leif
> >
> > This should be documented somewhere under
> > Documentation/devicetree/bindings/
> >
> > Not sure where thought. Maybe a top level chosen.txt?
> 
> Actually, this one doesn't. It is already documented in ePAPR

Hi Grant

Humm, do i have an old version of ePAPR?

All i see is that in Table 3-4 It says:

stdout-path O <string> A string that specifies the full path to the
	      	       node representing the device to be used for
	      	       boot console output. If the character ":" is
	      	       present in the value it terminates the
	      	       path. The value may be an alias.

		       If the stdin-path property is not specified,
		       stdout-path should be assumed to define the input device.

So what is before the : is defined. What comes afterwards,
baudrate/parity/bits/flow control does not appear to the defined in
ePAPR. Should we not document the extension being added here?

       Andrew