[RFC PATCH v2 2/4] Documentation: arm64/arm: dt bindings for numa.

[Hanjun Guo]

Hi Arnd,

On 2014年11月25日 19:02, Arnd Bergmann wrote:
> On Tuesday 25 November 2014 17:42:44 Hanjun Guo wrote:
>> On 2014-11-25 11:55, Shannon Zhao wrote:
>>> Hi,
>>>
>>> On 2014/11/22 5:23, Ganapatrao Kulkarni wrote:
>> [...]
>>>> +==============================================================================
>>>> +4 - Example dts
>>>> +==============================================================================
>>>> +
>>>> +Example 1: 2 Node system each having 8 CPUs and a Memory.
>>>> +
>>>> +    numa-map {
>>>> +            #address-cells = <2>;
>>>> +            #size-cells = <1>;
>>>> +            #node-count = <2>;
>>>> +            mem-map =  <0x0 0x00000000 0>,
>>>> +                       <0x100 0x00000000 1>;
>>>> +
>>>> +            cpu-map = <0 7 0>,
>>>> +                      <8 15 1>;
>>>
>>> The cpu range is continuous here. But if there is a situation like below:
>>>
>>> 0 2 4 6 belong to node 0
>>> 1 3 5 7 belong to node 1
>>>
>>> This case is very common on X86. I don't know the real situation of arm as
>>> I don't have a hardware with 2 nodes.
>>>
>>> How can we generate a DTS about this situation? like below? Can be parsed?
>>>
>>>                cpu-map = <0 2 4 6 0>,
>>>                          <1 3 5 7 1>;
>>
>> I think the binding proposed here can not cover your needs, and I think this
>> binding is not suitable, there are some reasons.
>>
>>   - CPU logical ID is allocated by OS, and it depends on the order of CPU node
>>     in the device tree, so it may be in a clean order like this patch proposed,
>>     or it will like the order Shannon pointed out.
>>
>>   - Since CPU logical ID is allocated by OS, DTS file will not know these
>>     numbers.
>
> Also:
>
> - you cannot support hierarchical NUMA topology
>
> - you cannot have CPU-less or memory-less nodes
>
> - you cannot associate I/O devices with NUMA nodes, only memory and CPU

Yes, I agree.

>
>> So the problem behind this is the mappings between CPUs and NUMA nodes,
>> there is already mapping for CPU hardware ID (MPIDR) and CPU logical ID,
>> and MPIDR will be not changed, why not using MPIDR for the mapping of
>> NUMA node and CPU? then the mappings will be:
>>
>> CPU logical ID <------> CPU MPIDR <-----> NUMA node ID <-----> proximity domain
>> (allocated by OS)      (constant)       (allocated by OS)
>
> No, don't hardcode ARM specifics into a common binding either. I've looked
> at the ibm,associativity properties again, and I think we should just use
> those, they can cover all cases and are completely independent of the
> architecture. We should probably discuss about the property name though,
> as using the "ibm," prefix might not be the best idea.

Is there any doc/code related to this? please give me some hints and I
will read that.

Thanks
Hanjun