[PATCH v3 00/11] Add stih410 SoC/board and USB2/1.1 support for stih416

[Peter Griffin]

Hi folks,

This series adds the required device tree nodes to enable the usb2/1.1 phy
and usb2/1.1 controllers on the stih416-b2120 board.

It additionally re-works and adds support for the new stih410 SoC which is
very similar to the stih407 SoC, by abstracting out the common parts
into common dt files.

After Arnds feedback regarding mixing address spaces in the stih407-picophy
dt nodes, I've tempoarily removed these patches from the series until the
underlying driver has been fixed, as ideally I would like to get the rest
of this series into 3.19

As well as adding dt nodes it also enables the relevant drivers in the 
multi_v7_defconfig.

Finally we update the default bootargs for stih407-b2120 and stih410-b2120
to boot with the clk_ignore_unused kernel parameter so as not to hang
the SoC when the (as yet) unreferenced interconnect clocks get disabled
by CCF (this is a tempoary solution).

This series has been tested on stih416-b2020 and stih410-b2120 SoC/boards.

Changes since v1:
- Leave bootargs & memory dt nodes in board files (Arnd)
- Remove '0x' from the unit address in all instances. (Arnd)
- Remove 'status="okay"' from some nodes (Arnd)
- Remove some legacy extra nodes which only contain status property (Arnd)
- Fix stih410 commit description (Maxime)
- Add a stih410.dtsi and stih410-pinctrl.dtsi files (Maxime)
- Remove superflous '\n' (Lee)
- Add a '\n' between the sentries and #include (Lee)

Changes since v2:
- Remove picophy and ehci/ohci dt nodes for stih407 / stih410 until reg binding is fixed
- Update miphy365 over to common convention of phy@ (Arnd)

Peter Griffin (11):
  ARM: STi: DT: STiH416: Add pinctl setup for usb controllers.
  ARM: STi: DT: STiH416: Add DT node for the stih415/6 usb2 phy
  ARM: STi: DT: STiH416: Add DT nodes for the ehci and ohci usb
    controllers.
  ARM: multi_v7_defconfig: Enable st ohci and ehci HCD drivers.
  ARM: multi_v7_defconfig: Enable stih415/6 usb2 phy driver.
  ARM: STi: DT: STiH410: Add defines for STiH410 DT clocks
  ARM: STi: DT: STiH410:  Add pinctl config for usb controllers.
  ARM: STi: DT: STih407: Abstract common dt nodes into shared files.
  ARM: STi: DT: STiH410: Add STiH410 SoC and b2120 board support.
  ARM: STi: DT: STih407: STih410: Add clk_ignore_unused to kernel
    bootargs
  ARM: STi: DT: STiH416: Change miphy356 node name to phy at fe382000

 arch/arm/boot/dts/Makefile               |   1 +
 arch/arm/boot/dts/stih407-b2120.dts      |  55 +----
 arch/arm/boot/dts/stih407-family.dtsi    | 278 +++++++++++++++++++++++++
 arch/arm/boot/dts/stih407.dtsi           | 279 -------------------------
 arch/arm/boot/dts/stih410-b2120.dts      |  29 +++
 arch/arm/boot/dts/stih410-clock.dtsi     | 338 +++++++++++++++++++++++++++++++
 arch/arm/boot/dts/stih410-pinctrl.dtsi   |  34 ++++
 arch/arm/boot/dts/stih410.dtsi           |  14 ++
 arch/arm/boot/dts/stih416-b2020.dts      |   2 +-
 arch/arm/boot/dts/stih416-b2020e.dts     |   2 +-
 arch/arm/boot/dts/stih416-pinctrl.dtsi   |  34 ++++
 arch/arm/boot/dts/stih416.dtsi           | 131 +++++++++++-
 arch/arm/boot/dts/stihxxx-b2120.dtsi     |  59 ++++++
 arch/arm/configs/multi_v7_defconfig      |   3 +
 include/dt-bindings/clock/stih410-clks.h |  25 +++
 15 files changed, 951 insertions(+), 333 deletions(-)
 create mode 100644 arch/arm/boot/dts/stih407-family.dtsi
 delete mode 100644 arch/arm/boot/dts/stih407.dtsi
 create mode 100644 arch/arm/boot/dts/stih410-b2120.dts
 create mode 100644 arch/arm/boot/dts/stih410-clock.dtsi
 create mode 100644 arch/arm/boot/dts/stih410-pinctrl.dtsi
 create mode 100644 arch/arm/boot/dts/stih410.dtsi
 create mode 100644 arch/arm/boot/dts/stihxxx-b2120.dtsi
 create mode 100644 include/dt-bindings/clock/stih410-clks.h

-- 
1.9.1