[PATCH v3 3/6] mfd: ti_am335x_tscadc: Remove unwanted reg_se_cache save

[Vignesh R]

In one shot mode, sequencer automatically disables all enabled steps at
the end of each cycle. (both ADC steps and TSC steps) Hence these steps
need not be saved in reg_se_cache for clearing these steps at a later
stage.
Also, when ADC wakes up Sequencer should not be busy executing any of the
config steps except for the charge step. Previously charge step was 1 ADC
clock cycle and hence it was ignored.

Signed-off-by: Vignesh R <vigneshr at ti.com>
---
 drivers/mfd/ti_am335x_tscadc.c       | 7 +++++--
 include/linux/mfd/ti_am335x_tscadc.h | 1 +
 2 files changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/mfd/ti_am335x_tscadc.c b/drivers/mfd/ti_am335x_tscadc.c
index d877e777cce6..110038859a8d 100644
--- a/drivers/mfd/ti_am335x_tscadc.c
+++ b/drivers/mfd/ti_am335x_tscadc.c
@@ -86,8 +86,12 @@ static void am335x_tscadc_need_adc(struct ti_tscadc_dev *tsadc)
 		spin_lock_irq(&tsadc->reg_lock);
 		finish_wait(&tsadc->reg_se_wait, &wait);
 
+		/*
+		 * Sequencer should either be idle or
+		 * busy applying the charge step.
+		 */
 		reg = tscadc_readl(tsadc, REG_ADCFSM);
-		WARN_ON(reg & SEQ_STATUS);
+		WARN_ON((reg & SEQ_STATUS) && !(reg & CHARGE_STEP));
 		tsadc->adc_waiting = false;
 	}
 	tsadc->adc_in_use = true;
@@ -96,7 +100,6 @@ static void am335x_tscadc_need_adc(struct ti_tscadc_dev *tsadc)
 void am335x_tsc_se_set_once(struct ti_tscadc_dev *tsadc, u32 val)
 {
 	spin_lock_irq(&tsadc->reg_lock);
-	tsadc->reg_se_cache |= val;
 	am335x_tscadc_need_adc(tsadc);
 
 	tscadc_writel(tsadc, REG_SE, val);
diff --git a/include/linux/mfd/ti_am335x_tscadc.h b/include/linux/mfd/ti_am335x_tscadc.h
index c99be5dc0f5c..fcce182e4a35 100644
--- a/include/linux/mfd/ti_am335x_tscadc.h
+++ b/include/linux/mfd/ti_am335x_tscadc.h
@@ -128,6 +128,7 @@
 
 /* Sequencer Status */
 #define SEQ_STATUS BIT(5)
+#define CHARGE_STEP		0x11
 
 #define ADC_CLK			3000000
 #define TOTAL_STEPS		16
-- 
1.9.1