[PATCH v4 REPOST 4/5] ARM: tegra: Add PMC thermtrip programming to Jetson TK1 device tree

Mikko Perttunen mikko.perttunen at kapsi.fi
Mon Nov 10 05:12:16 PST 2014


From: Mikko Perttunen <mperttunen at nvidia.com>

This adds the required information to reset the board during an overheating
situation to the Jetson TK1 device tree. The thermal reset is handled by the
PMC by sending an I2C message to the PMIC. The entries specify the I2C
message to be sent.

Signed-off-by: Mikko Perttunen <mperttunen at nvidia.com>
Reviewed-by: Wei Ni <wni at nvidia.com>
Tested-by: Wei Ni <wni at nvidia.com>
---
 arch/arm/boot/dts/tegra124-jetson-tk1.dts | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/tegra124-jetson-tk1.dts b/arch/arm/boot/dts/tegra124-jetson-tk1.dts
index f46a789..57ead69 100644
--- a/arch/arm/boot/dts/tegra124-jetson-tk1.dts
+++ b/arch/arm/boot/dts/tegra124-jetson-tk1.dts
@@ -1457,7 +1457,7 @@
 	};
 
 	/* Expansion PWR_I2C_*, on-board components */
-	i2c at 0,7000d000 {
+	pmic_bus: i2c at 0,7000d000 {
 		status = "okay";
 		clock-frequency = <400000>;
 
@@ -1672,6 +1672,13 @@
 		nvidia,core-pwr-off-time = <61036>;
 		nvidia,core-power-req-active-high;
 		nvidia,sys-clock-req-active-high;
+
+		i2c-thermtrip {
+			nvidia,i2c-bus = <&pmic_bus>;
+			nvidia,bus-addr = <0x40>;
+			nvidia,reg-addr = <0x36>;
+			nvidia,reg-data = <0x2>;
+		};
 	};
 
 	/* Serial ATA */
-- 
2.1.3




More information about the linux-arm-kernel mailing list