[PATCH 0/8] Armada XP pinctrl consolidation and ix4-300d fixes

[Jason Cooper]

On Sat, Nov 01, 2014 at 11:48:33PM +0100, Sebastian Hesselbarth wrote:
> On 01.11.2014 23:36, Jason Cooper wrote:
> >On Fri, Sep 19, 2014 at 10:14:36PM +0200, Sebastian Hesselbarth wrote:
> >>this is a patch set preparing barebox support for ix4-300d. As usual,
> >>I stumbled upon a few nice-to-haves before actually touching ix4-300d
> >>dts. As it is a mach-mvebu thing, I just added the related mailing
> >>lists instead of each of the DT maintainers.
> >>
> >>First 5 patches consolidate SoC-specific pinctrl nodes to one common
> >>node in armada-xp.dtsi, compatible overwrites for each SoC, and node
> >>alias usage for each board. Also, ge{0,1} pinctrl settings are moved
> >>to the common node from one board specific node.
> >>
> >>Last 3 patches then use that ge{0,1} pinctrl settings on ix4-300d which
> >>is vital for bootloader init. During exploration of ix4-300d, I also
> >>found a i2c eeprom that has not been added to the dts, yet. Finally,
> >>there is only one 74hc595 on ix4 mainboard while dts property is set
> >>for two.
> >>
> >>I cannot recall in detail what is on that eeprom, but IIRC it is nothing
> >>important. Some reg,addr pairs for some init stuff that should have
> >>already been done by stock u-boot. Anyway, adding the node will do no
> >>harm.
> >>
> >>Patches are based on v3.17-rc1 and intended for v3.18 but I am not in
> >>a hurry. I only compile tested this, so a formal Tested-by from Benoit
> >>for the ix4 and any other Armada XP board would be great.
> >
> >I lost track of this thread, are you resending?  Did Benoit get a
> >successful test run?
> 
> Looks like there was this A0 stepping thing, but basically yes
> 
> http://www.spinics.net/lists/devicetree/msg53364.html
> 
> I have just rebased it on top of v3.18-rc1, feel free to pick them
> up from
> 
> git://git.infradead.org/users/hesselba/linux-berlin.git devel/mvebu/ix4-300d
> git://git.infradead.org/users/hesselba/linux-berlin.git

Ahh, that's right.  Do you still use the github repo?  I hadn't added
your infradead as a remote yet.

At any rate, I cherry-picked them and added Benoit's Tested-by's.  So if
you had this branch in -next, please remove it before tonight's run.

Applied to mvebu/dt.

thx,

Jason.