[PATCH 2/2] arm: shmobile: r8a7790: add USB3.0 node to r8a7790.dtsi

[Yoshihiro Shimoda]

Hello.

(2014/05/30 22:08), Sergei Shtylyov wrote:
> Hello.
> 
> On 05/30/2014 04:14 PM, Yoshihiro Shimoda wrote:
> 
>>>> Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh at renesas.com>
>>>> ---
>>>>    arch/arm/boot/dts/r8a7790.dtsi |   10 ++++++++++
>>>>    1 file changed, 10 insertions(+)
> 
>>>> diff --git a/arch/arm/boot/dts/r8a7790.dtsi b/arch/arm/boot/dts/r8a7790.dtsi
>>>> index e06c486..e6b04f2 100644
>>>> --- a/arch/arm/boot/dts/r8a7790.dtsi
>>>> +++ b/arch/arm/boot/dts/r8a7790.dtsi
>>>> @@ -902,4 +902,14 @@
>>>>            #size-cells = <0>;
>>>>            status = "disabled";
>>>>        };
>>>> +
>>>> +    xhci: xhci at ee000000 {
> 
>>>      The node name should be "usb at ee000000", according to section 2.2.2 of the
>>> ePAPR standard [1]:
> 
>> Thank you for the point! I will fix this and r8a7791's one.
> 
>>>> +        compatible = "renesas,xhci-r8a7790";
>>>> +        reg = <0 0xee000000 0 0xc00>;
>>>> +        interrupts = <0 101 IRQ_TYPE_LEVEL_HIGH>;
>>>> +        clocks = <&mstp3_clks R8A7790_CLK_SSUSB>;
>>>> +        phys = <&usbphy 1 1>;
> 
>>>      This part is dependent on the generic PHY support in the USB HCD in order
>>> to work.
> 
>    Oops, I hadn't seen that you added generic PHY support to the xHCI driver when writing this. I'm however for adding the generic PHY support to the generic USB HCD code, so that we can use it for the PCI controllers.
> 
>> This means that I should wait to add this parameter until the generic USB PHY Gen2
>> driver is supported in upstream?
> 
>    At least describe that dependency.

Thank you for the reply! I will add such a describption in change log.

Best regards,
Yoshihiro Shimoda

>> Best regards,
>> Yoshihiro Shimoda
> 
> WBR, Sergei
> 

-- 
Yoshihiro Shimoda