linux-next: manual merge of the omap_dss2 tree with the arm-soc tree
Stephen Rothwell
sfr at canb.auug.org.au
Thu May 29 20:38:04 PDT 2014
Hi Tomi,
Today's linux-next merge of the omap_dss2 tree got a conflict in
arch/arm/boot/dts/am437x-gp-evm.dts between commit 99ffa6425f1b ("ARM:
dts: am437x-gp-evm: add support for parallel NAND flash") from the
arm-soc tree and commit 0186bec97131 ("ARM: dts: am437x-gp-evm: add LCD
data") from the omap_dss2 tree.
I fixed it up (see below) and can carry the fix as necessary (no action
is required).
--
Cheers,
Stephen Rothwell sfr at canb.auug.org.au
diff --cc arch/arm/boot/dts/am437x-gp-evm.dts
index c25d15837ce9,3acccdf258e9..000000000000
--- a/arch/arm/boot/dts/am437x-gp-evm.dts
+++ b/arch/arm/boot/dts/am437x-gp-evm.dts
@@@ -151,26 -193,46 +193,67 @@@
>;
};
+ nand_flash_x8: nand_flash_x8 {
+ pinctrl-single,pins = <
+ 0x26c(PIN_OUTPUT_PULLDOWN | MUX_MODE7) /* spi2_cs0.gpio/eMMCorNANDsel */
+ 0x0 (PIN_INPUT | MUX_MODE0) /* gpmc_ad0.gpmc_ad0 */
+ 0x4 (PIN_INPUT | MUX_MODE0) /* gpmc_ad1.gpmc_ad1 */
+ 0x8 (PIN_INPUT | MUX_MODE0) /* gpmc_ad2.gpmc_ad2 */
+ 0xc (PIN_INPUT | MUX_MODE0) /* gpmc_ad3.gpmc_ad3 */
+ 0x10 (PIN_INPUT | MUX_MODE0) /* gpmc_ad4.gpmc_ad4 */
+ 0x14 (PIN_INPUT | MUX_MODE0) /* gpmc_ad5.gpmc_ad5 */
+ 0x18 (PIN_INPUT | MUX_MODE0) /* gpmc_ad6.gpmc_ad6 */
+ 0x1c (PIN_INPUT | MUX_MODE0) /* gpmc_ad7.gpmc_ad7 */
+ 0x70 (PIN_INPUT_PULLUP | MUX_MODE0) /* gpmc_wait0.gpmc_wait0 */
+ 0x74 (PIN_OUTPUT_PULLUP | MUX_MODE7) /* gpmc_wpn.gpmc_wpn */
+ 0x7c (PIN_OUTPUT | MUX_MODE0) /* gpmc_csn0.gpmc_csn0 */
+ 0x90 (PIN_OUTPUT | MUX_MODE0) /* gpmc_advn_ale.gpmc_advn_ale */
+ 0x94 (PIN_OUTPUT | MUX_MODE0) /* gpmc_oen_ren.gpmc_oen_ren */
+ 0x98 (PIN_OUTPUT | MUX_MODE0) /* gpmc_wen.gpmc_wen */
+ 0x9c (PIN_OUTPUT | MUX_MODE0) /* gpmc_be0n_cle.gpmc_be0n_cle */
+ >;
+ };
++
+ dss_pins: dss_pins {
+ pinctrl-single,pins = <
+ 0x020 (PIN_OUTPUT_PULLUP | MUX_MODE1) /*gpmc ad 8 -> DSS DATA 23 */
+ 0x024 (PIN_OUTPUT_PULLUP | MUX_MODE1)
+ 0x028 (PIN_OUTPUT_PULLUP | MUX_MODE1)
+ 0x02c (PIN_OUTPUT_PULLUP | MUX_MODE1)
+ 0x030 (PIN_OUTPUT_PULLUP | MUX_MODE1)
+ 0x034 (PIN_OUTPUT_PULLUP | MUX_MODE1)
+ 0x038 (PIN_OUTPUT_PULLUP | MUX_MODE1)
+ 0x03c (PIN_OUTPUT_PULLUP | MUX_MODE1) /*gpmc ad 15 -> DSS DATA 16 */
+ 0x0a0 (PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS DATA 0 */
+ 0x0a4 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0a8 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0ac (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0b0 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0b4 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0b8 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0bc (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0c0 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0c4 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0c8 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0cc (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0d0 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0d4 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0d8 (PIN_OUTPUT_PULLUP | MUX_MODE0)
+ 0x0dc (PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS DATA 15 */
+ 0x0e0 (PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS VSYNC */
+ 0x0e4 (PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS HSYNC */
+ 0x0e8 (PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS PCLK */
+ 0x0ec (PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS AC BIAS EN */
+
+ >;
+ };
+
+ lcd_pins: lcd_pins {
+ pinctrl-single,pins = <
+ /* GPIO 5_8 to select LCD / HDMI */
+ 0x238 (PIN_OUTPUT_PULLUP | MUX_MODE7)
+ >;
+ };
};
&i2c0 {
@@@ -273,89 -330,16 +356,103 @@@
phy-mode = "rgmii";
};
+&elm {
+ status = "okay";
+};
+
+&gpmc {
+ status = "okay";
+ pinctrl-names = "default";
+ pinctrl-0 = <&nand_flash_x8>;
+ ranges = <0 0 0 0x01000000>; /* minimum GPMC partition = 16MB */
+ nand at 0,0 {
+ reg = <0 0 4>; /* device IO registers */
+ ti,nand-ecc-opt = "bch8";
+ ti,elm-id = <&elm>;
+ nand-bus-width = <8>;
+ gpmc,device-width = <1>;
+ gpmc,sync-clk-ps = <0>;
+ gpmc,cs-on-ns = <0>;
+ gpmc,cs-rd-off-ns = <40>;
+ gpmc,cs-wr-off-ns = <40>;
+ gpmc,adv-on-ns = <0>;
+ gpmc,adv-rd-off-ns = <25>;
+ gpmc,adv-wr-off-ns = <25>;
+ gpmc,we-on-ns = <0>;
+ gpmc,we-off-ns = <20>;
+ gpmc,oe-on-ns = <3>;
+ gpmc,oe-off-ns = <30>;
+ gpmc,access-ns = <30>;
+ gpmc,rd-cycle-ns = <40>;
+ gpmc,wr-cycle-ns = <40>;
+ gpmc,wait-pin = <0>;
+ gpmc,wait-on-read;
+ gpmc,wait-on-write;
+ gpmc,bus-turnaround-ns = <0>;
+ gpmc,cycle2cycle-delay-ns = <0>;
+ gpmc,clk-activation-ns = <0>;
+ gpmc,wait-monitoring-ns = <0>;
+ gpmc,wr-access-ns = <40>;
+ gpmc,wr-data-mux-bus-ns = <0>;
+ /* MTD partition table */
+ /* All SPL-* partitions are sized to minimal length
+ * which can be independently programmable. For
+ * NAND flash this is equal to size of erase-block */
+ #address-cells = <1>;
+ #size-cells = <1>;
+ partition at 0 {
+ label = "NAND.SPL";
+ reg = <0x00000000 0x00040000>;
+ };
+ partition at 1 {
+ label = "NAND.SPL.backup1";
+ reg = <0x00040000 0x00040000>;
+ };
+ partition at 2 {
+ label = "NAND.SPL.backup2";
+ reg = <0x00080000 0x00040000>;
+ };
+ partition at 3 {
+ label = "NAND.SPL.backup3";
+ reg = <0x000c0000 0x00040000>;
+ };
+ partition at 4 {
+ label = "NAND.u-boot-spl-os";
+ reg = <0x00100000 0x00080000>;
+ };
+ partition at 5 {
+ label = "NAND.u-boot";
+ reg = <0x00180000 0x00100000>;
+ };
+ partition at 6 {
+ label = "NAND.u-boot-env";
+ reg = <0x00280000 0x00040000>;
+ };
+ partition at 7 {
+ label = "NAND.u-boot-env.backup1";
+ reg = <0x002c0000 0x00040000>;
+ };
+ partition at 8 {
+ label = "NAND.kernel";
+ reg = <0x00300000 0x00700000>;
+ };
+ partition at 9 {
+ label = "NAND.file-system";
+ reg = <0x00a00000 0x1f600000>;
+ };
+ };
+};
++
+ &dss {
+ status = "ok";
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&dss_pins>;
+
+ port {
+ dpi_out: endpoint at 0 {
+ remote-endpoint = <&lcd_in>;
+ data-lines = <24>;
+ };
+ };
+ };
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20140530/ef2404a9/attachment.sig>
More information about the linux-arm-kernel
mailing list