[PATCH 0/5] serial: imx: fixes

[Dirk Behme]

Am 28.05.2014 21:34, schrieb Greg KH:
> On Fri, May 09, 2014 at 04:19:43PM +0100, dean_jenkins at mentor.com wrote:
>> From: Dean Jenkins <Dean_Jenkins at mentor.com>
>>
>> The following set of patches were tested on an i.MX6 multi-core platform.
>>
>> Patches 1 to 4 were tested using a Bluetooth BCSP UART connection at 115.2kbps
>> and 4Mbps. The fixes were needed because the i.MX6 UART driver caused spinlock
>> deadlocks with the HCI TTY layer.
>>
>> Patch 5 improves the i.MX6 UART driver for use with kdb.
>>
>> Patch 1: serial: imx: remove unneeded imx_transmit_buffer() from imx_start_tx()
>> Patch 2: serial: imx: remove uart_write_wakeup() from imx_transmit_buffer()
>> Patch 3: serial: imx: avoid spinlock recursion deadlock
>> Patch 4: serial: imx: move imx_transmit_buffer() into imx_txint()
>> Patch 5: serial: imx: clean up imx_poll_get_char()
>>
>> The patches are based off 3.15-rc4.
>>
>> ----------------------------------------------------------------
>> Andy Lowe (1):
>>        serial: imx: avoid spinlock recursion deadlock
>>
>> Dirk Behme (4):
>>        serial: imx: remove unneeded imx_transmit_buffer() from imx_start_tx()
>>        serial: imx: remove uart_write_wakeup() from imx_transmit_buffer()
>>        serial: imx: move imx_transmit_buffer() into imx_txint()
>>        serial: imx: clean up imx_poll_get_char()
>>
>>   drivers/tty/serial/imx.c |   73 ++++++++++++++--------------------------------
>>   1 file changed, 22 insertions(+), 51 deletions(-)
>
> Given the rather confusing threads based on these patches, I don't know
> what to apply.
>
> Dean, can you respin what patches you want applied

Well, we think patches #1-#4 are correct and should be applied, but 
Huang has the opinion that this is fixed already in the BT stack. If 
Huang doesn't change his mind, then let's drop #1-#4.

Patch #5 addresses an other topic and therefore should be resent, then.

Best regards

Dirk