[PATCH 1/3] gpio: Add APM X-Gene SoC GPIO controller support

[Linus Walleij]

On Tue, May 27, 2014 at 6:59 PM, Feng Kan <fkan at apm.com> wrote:

> I will break out the gpio to separate
> device nodes as instructed, I will have to use the reg attribute to offset
> bank registers. Please let me know if it is acceptable.

Yeah sure regs = <a>, <b>, <c> for a single node is OK if that's what
you mean.

> gfc_gpio_fl0              GFC42'h1701c00c
> gfc_gpio_fl0_mux      GFC42'h1701c010
> gfc_gpio_fl1              GFC42'h1701c018
> gfc_gpio_fl1_mux      GFC42'h1701c01c
> gfc_gpio_fl2              GFC42'h1701c024
> gfc_gpio_fl2_mux      GFC42'h1701c028
> gfc_gpio_fl0_od        GFC42'h1701c030
> gfc_gpio_fl1_od        GFC42'h1701c034
> gfc_gpio_fl2_od        GFC42'h1701c038

Strange syntax in the last line there. GFC42'h uhm.

But that looks a bit mingled actually. However I think you will be
much happier if you split it into individual devices as I wanted to.
It will be easier to maintain and simpler code even if the device tree
may look a bit strange.

Yours,
Linus Walleij