[PATCH v3 1/5] sc_phy:SmartCard(SC) PHY interface to SC controller

[Greg KH]

On Wed, May 28, 2014 at 02:27:13PM +0530, Satish Patel wrote:
> SmartCard controller uses this interface to communicate with
> SmartCard via PHY
> 
> Some SmartCard PHY has multiple slots for cards.
> This inerface also enables controller to communicate
> with one or more SmartCard connected over phy.
> 
> interface structure includes following APIs
> - set/get config
> - activate/deactivate smart card
> - warm reset
> - register_notify (for card insert/remove/overheat)
> - unregister_notify
> 
> Signed-off-by: Satish Patel <satish.patel at ti.com>
> ---
>  Documentation/sc_phy.txt |  171 ++++++++++++++++++++++++++++++++++++++++++++++
>  include/linux/sc_phy.h   |  136 ++++++++++++++++++++++++++++++++++++
>  2 files changed, 307 insertions(+)
>  create mode 100644 Documentation/sc_phy.txt
>  create mode 100644 include/linux/sc_phy.h

These are .h files, but where is the "api" functions that use
these structures defined at?

confused,

greg k-h