[PATCH v2 4/4] ARM: debug: qcom: add UART addresses to Kconfig help

[Matthias Brugger]

2014-05-26 15:45 GMT+02:00 Georgi Djakov <gdjakov at mm-sol.com>:
> On 23.05.14, 19:39, Matthias Brugger wrote:
>>
>> 2014-05-23 17:12 GMT+02:00 Georgi Djakov <gdjakov at mm-sol.com>:
>>>
>>> Add information about the APQ8084 debug UART physical and virtual
>>> addresses in the DEBUG_QCOM_UARTDM Kconfig help section.
>>> Requires: https://lkml.org/lkml/2014/4/14/312
>>>
>>> Signed-off-by: Georgi Djakov <gdjakov at mm-sol.com>
>>> ---
>>>  arch/arm/Kconfig.debug |    1 +
>>>  1 file changed, 1 insertion(+)
>>>
>>> diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
>>> index 40ee328..e71723d 100644
>>> --- a/arch/arm/Kconfig.debug
>>> +++ b/arch/arm/Kconfig.debug
>>> @@ -376,6 +376,7 @@ choice
>>>                   their output to the serial port on Qualcomm devices.
>>>
>>>                   ARCH      DEBUG_UART_PHYS   DEBUG_UART_BASE
>>> +                 APQ8084   0xf995e000        0xfa75e000
>>>                   MSM8X60   0x19c40000        0xf0040000
>>>                   MSM8960   0x16440000        0xf0040000
>>>                   MSM8974   0xf991e000        0xfa71e000
>>
>>
>> You don't have any uart defined in your dts. You should add them
>> before any adding low level debug support.
>> Otherwise there might be problems in booting a multi-platform kernel.
>>
>
> Thanks for the comment! As the uart depends on clocks, i am adding it to the
> dts as part of my global clock controller patchset [1].
> In this patch i am just adding some information to the help section.
> Do you see any problem with this?

Are the patches for the clock controller applied already?
If not, I would consider to add this patch to clock controller series.

Cheers,
Matthias

>
> [1] https://lkml.org/lkml/2014/5/22/422
>
> Thanks,
> Georgi



-- 
motzblog.wordpress.com