[PATCH for v3.15 0/2] ARM: mvebu Specificy ECC scheme for A375/385 boards

[Jason Cooper]

On Sat, May 24, 2014 at 11:17:08AM -0300, Ezequiel Garcia wrote:
> Last minute fixes, which help prevent any inconsistencies between the ECC
> scheme expected by the bootloader, and the one expected by the kernel.
> 
> Until now, the kernel was using the ONFI-provided "datasheet ECC requirement",
> and assume the bootloader did the same thing. However, this is not the case
> for these boards, where the vendor provided a bootloader with an ECC strength
> that's weaker than the required.
> 
> After the introduction of the NAND ECC devicetree binding, and its support
> in the pxa3xx-nand driver, we can set these values and expect them to work.
> 
> I hope it's not too late for v3.15 already.
> 
> Ezequiel Garcia (2):
>   ARM: dts: Specify the NAND ECC scheme explicitly on Armada 375 DB
>     board
>   ARM: dts: Specify the NAND ECC scheme explicitly on Armada 385 DB
>     board
> 
>  arch/arm/boot/dts/armada-375-db.dts | 2 ++
>  arch/arm/boot/dts/armada-385-db.dts | 2 ++
>  2 files changed, 4 insertions(+)

As discussed on irc, I'm pushing this for v3.16 right now.  If we later
determine that it needs to be in v3.15, we can send a stable request for
these patches.

Applied to mvebu/dt for v3.16

thx,

Jason.