[PATCH v2 09/10] mtd: st_spi_fsm: Provide mask to obtain correct boot device pins

Lee Jones lee.jones at linaro.org
Thu May 22 04:56:43 PDT 2014


mtd: st_spi_fsm: Provide documentation for boot device mask property

The system configuration registers which display which device the system
booted on are in the same place on all boards which support the FSM.
However, the bits do shift every so slightly.  To combat these we're
adding a new property which supplies the necessary mask used to abstract
the required information.

Cc: devicetree at vger.kernel.org
Signed-off-by: Lee Jones <lee.jones at linaro.org>

diff --git a/Documentation/devicetree/bindings/mtd/st-fsm.txt b/Documentation/devicetree/bindings/mtd/st-fsm.txt
index c248939..2ef9710 100644
--- a/Documentation/devicetree/bindings/mtd/st-fsm.txt
+++ b/Documentation/devicetree/bindings/mtd/st-fsm.txt
@@ -11,6 +11,10 @@ Optional properties:
   - st,syscfg          : Phandle to boot-device system configuration registers
   - st,boot-device-reg : Address of the aforementioned boot-device register(s)
   - st,boot-device-spi : Expected boot-device value if booted via this device
+  - st,boot-device-msk : Mask to use when extracting boot device from the
+                        above system config registers
+  NB: If any of the st,boot-device-* properties are missing, the driver falls
+  back to the default assumption of 'booted from SPI'.
 
 Example:
        spifsm: spifsm at fe902000{



More information about the linux-arm-kernel mailing list