[Patch v4 2/5] Power: reset: add bindings for keystone reset driver

Santosh Shilimkar santosh.shilimkar at ti.com
Wed May 21 09:09:50 PDT 2014


On Wednesday 21 May 2014 12:07 PM, Arnd Bergmann wrote:
> On Wednesday 21 May 2014 19:03:38 Ivan Khoronzhuk wrote:
>>
>> I've slightly confused where should I add these bindings.
>> The main pll controller mostly used by clk driver....
>> As its register set is used also by reset driver it's logically to put 
>> it to bindings/mfd,
>> but pll controller in mfd it's strange....
>>
>> Could you please help to decide where should it be?.
> 
> Put it into Documentation/devicetree/bindings/clock/keystone-pll.txt
> 
I was just about post the same suggestion. Lets do that.

regards,
Santosh




More information about the linux-arm-kernel mailing list