[Patch v4 4/5] ARM: dts: keystone: update reset node to work with reset driver

[Ivan Khoronzhuk]

On 05/21/2014 05:50 PM, Arnd Bergmann wrote:
> On Wednesday 21 May 2014 17:27:33 Ivan Khoronzhuk wrote:
>> The keystone driver requires the next additional properties:
>>
>> "ti,syscon-pll" - syscon register range used to access pll controller
>>                    registers in order to use reset control registers.
>> "ti,syscon-dev" - syscon register range used to access device state
>>                    control registers in order to use mux block
>>                    registers for all watchdogs.
>>
>> "ti,wdt_list"   - option to declare what watchdog are used to reboot
>>                    the SoC, so set "0" WDT as default.
>>
>> Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk at ti.com>
> Same comment as what I had for the binding: it's not a register range
> any more, but a phandle for a device.
>
>> ---
>>   arch/arm/boot/dts/keystone.dtsi | 4 +++-
>>   1 file changed, 3 insertions(+), 1 deletion(-)
>>
>> diff --git a/arch/arm/boot/dts/keystone.dtsi b/arch/arm/boot/dts/keystone.dtsi
>> index 8b899ba..783da60 100644
>> --- a/arch/arm/boot/dts/keystone.dtsi
>> +++ b/arch/arm/boot/dts/keystone.dtsi
>> @@ -78,7 +78,9 @@
>>   
>>                  rstctrl: reset-controller {
>>                          compatible = "ti,keystone-reset";
>> -                       reg = <0x023100e8 4>;   /* pll reset control reg */
>> +                       ti,syscon-pll = <&pllctrl>;
>> +                       ti,syscon-dev = <&devctrl>;
>> +                       ti,wdt_list = <0>;
>>                  };
>>   
> I don't see a definition for the two labels, so this will cause a
> build error. It makes sense to add them in the same patch.
>
> 	Arnd

Thanks,

I'll correct

-- 
Regards,
Ivan Khoronzhuk