[PATCH v2] ARM: dts: duovero-parlor: Add HDMI output

[Tony Lindgren]

* Tomi Valkeinen <tomi.valkeinen at ti.com> [140521 05:04]:
> On 21/05/14 12:15, Florian Vaussard wrote:
> > Add the necessary DTS nodes to enable the micro-HDMI output on Parlor
> > board.
> > 
> > Signed-off-by: Florian Vaussard <florian.vaussard at epfl.ch>
> > ---
> > v1->v2:
> > - Rebased on Tony's omap-for-v3.16/dt-v2
> > - Use OMAP4_IOPAD macro
> > - Use hpd pin as GPIO with hdmi-connector
> > 
> >  arch/arm/boot/dts/omap4-duovero-parlor.dts | 44 ++++++++++++++++++++++++++++++
> >  1 file changed, 44 insertions(+)
> 
> Looks good to me.

Assuming Tomi will queue the display dts file separately:

Acked-by: Tony Lindgren <tony at atomide.com>