[PATCH v2 4/4] ARM: dts: bcm590xx: add support for GPLDO and VBUS regulators

[Matt Porter]

On Wed, May 21, 2014 at 10:29:13AM +0100, Lee Jones wrote:
> > Adds additional nodes to support GPLDO1-6 and VBUS regulators which
> > are now supported in the bcm590xx regulator driver.
> > 
> > Signed-off-by: Matt Porter <mporter at linaro.org>
> > ---
> >  arch/arm/boot/dts/bcm59056.dtsi | 21 +++++++++++++++++++++
> >  1 file changed, 21 insertions(+)
> 
> I'm not going to apply this with the rest of the set.  It will have to
> go in via your normal arch/arm route.

Ok

> > diff --git a/arch/arm/boot/dts/bcm59056.dtsi b/arch/arm/boot/dts/bcm59056.dtsi
> > index dfadaaa..066adfb 100644
> > --- a/arch/arm/boot/dts/bcm59056.dtsi
> > +++ b/arch/arm/boot/dts/bcm59056.dtsi
> > @@ -70,5 +70,26 @@
> >  
> >  		vsr_reg: vsr {
> >  		};
> > +
> > +		gpldo1_reg: gpldo1 {
> > +		};
> 
> What do these empty nodes do in any case?

They instantiate regulators. The bcm590xx binding specifies the
allowable subnode names permitted here. This replaces the old method
of specifying an index or the deprecated regulator-compatible property.
The board-specific dts includes this dtsi and applies any board
constraints to a subset of regulators that need them. Unused regulators
are all disabled which is what we want.

> Don't you at least need a status property in there or something?

Not necessary for these subnodes.

-Matt