[PATCH] ARM: sun6i: Enable USB Host support on the Colombus board
Hans de Goede
hdegoede at redhat.com
Tue May 20 05:07:35 PDT 2014
Hi,
On 05/20/2014 01:59 PM, Maxime Ripard wrote:
> The colombus board has a on-board USB hub, that is enabled through the pin
> PH24, and wired to the first EHCI controller.
ehci0 is not hooked up at all on this board ? I would expect it to go to
a usb wifi card for example.
Assuming that ehci0 is not hooked up, this is:
Reviewed-by: Hans de Goede <hdegoede at redhat.com>
If it is hooked up I believe both usb controllers should be enabled.
Regards,
Hans
>
> Signed-off-by: Maxime Ripard <maxime.ripard at free-electrons.com>
> ---
> arch/arm/boot/dts/sun6i-a31-colombus.dts | 26 ++++++++++++++++++++++++++
> 1 file changed, 26 insertions(+)
>
> diff --git a/arch/arm/boot/dts/sun6i-a31-colombus.dts b/arch/arm/boot/dts/sun6i-a31-colombus.dts
> index 3898a7bce831..a907c1d3e939 100644
> --- a/arch/arm/boot/dts/sun6i-a31-colombus.dts
> +++ b/arch/arm/boot/dts/sun6i-a31-colombus.dts
> @@ -13,6 +13,7 @@
>
> /dts-v1/;
> /include/ "sun6i-a31.dtsi"
> +/include/ "sunxi-common-regulators.dtsi"
>
> / {
> model = "WITS A31 Colombus Evaluation Board";
> @@ -23,6 +24,24 @@
> };
>
> soc at 01c00000 {
> + pio: pinctrl at 01c20800 {
> + usb2_vbus_pin_colombus: usb2_vbus_pin at 0 {
> + allwinner,pins = "PH24";
> + allwinner,function = "gpio_out";
> + allwinner,drive = <0>;
> + allwinner,pull = <0>;
> + };
> + };
> +
> + usbphy: phy at 01c19400 {
> + usb2_vbus-supply = <®_usb2_vbus>;
> + status = "okay";
> + };
> +
> + ehci1: usb at 01c1b000 {
> + status = "okay";
> + };
> +
> uart0: serial at 01c28000 {
> pinctrl-names = "default";
> pinctrl-0 = <&uart0_pins_a>;
> @@ -47,4 +66,11 @@
> status = "okay";
> };
> };
> +
> + reg_usb2_vbus: usb2-vbus {
> + pinctrl-names = "default";
> + pinctrl-0 = <&usb2_vbus_pin_colombus>;
> + gpio = <&pio 7 24 0>;
> + status = "okay";
> + };
> };
>
More information about the linux-arm-kernel
mailing list