[PATCH v2 0/5] Smart Card(SC) interface, TI USIM & NxP SC phy driver

[Satish Patel]

On 1/30/2014 6:35 PM, Greg KH wrote:
> On Thu, Jan 30, 2014 at 11:22:48AM +0530, Satish Patel wrote:
>> On 1/20/2014 10:03 AM, Satish Patel wrote:
>>> Changes from v1:
>>> * RFC(v1) comments are fixed
>>>
>>> ** removed "gpio_to_irq" as GPIO controller process  cell from DT and
>>> give it to DT node
>>> ** comments on documentation
>>> ** few other comments on null checks are resolved
>>>
>>> * BWT timing configuration is added to ti-usim driver
>>>
>>> v1 cover letter link#
>>> https://lkml.org/lkml/2014/1/6/250
>>>
>>> Satish Patel (5):
>>>    sc_phy:SmartCard(SC) PHY interface to SC controller
>>>    misc: tda8026: Add NXP TDA8026 PHY driver
>>>    char: ti-usim: Add driver for USIM module on AM43xx
>>>    ARM: dts: AM43xx: DT entries added for ti-usim
>>>    ARM: dts: AM43xx-epos-evm: DT entries  for ti-usim and phy
>>>
>>>   Documentation/devicetree/bindings/misc/tda8026.txt |   19 +
>>>   .../devicetree/bindings/ti-usim/ti-usim.txt        |   31 +
>>>   Documentation/sc_phy.txt                           |  171 ++
>>>   arch/arm/boot/dts/am4372.dtsi                      |   10 +
>>>   arch/arm/boot/dts/am43x-epos-evm.dts               |   43 +
>>>   drivers/char/Kconfig                               |    7 +
>>>   drivers/char/Makefile                              |    1 +
>>>   drivers/char/ti-usim-hw.h                          |  863 +++++++++
>>>   drivers/char/ti-usim.c                             | 1859 ++++++++++++++++++++
>>>   drivers/misc/Kconfig                               |    7 +
>>>   drivers/misc/Makefile                              |    1 +
>>>   drivers/misc/tda8026.c                             | 1255 +++++++++++++
>>>   include/linux/sc_phy.h                             |  132 ++
>>>   include/linux/ti-usim.h                            |   98 +
>>>   14 files changed, 4497 insertions(+), 0 deletions(-)
>>>   create mode 100644 Documentation/devicetree/bindings/misc/tda8026.txt
>>>   create mode 100644 Documentation/devicetree/bindings/ti-usim/ti-usim.txt
>>>   create mode 100644 Documentation/sc_phy.txt
>>>   create mode 100644 drivers/char/ti-usim-hw.h
>>>   create mode 100644 drivers/char/ti-usim.c
>>>   create mode 100644 drivers/misc/tda8026.c
>>>   create mode 100644 include/linux/sc_phy.h
>>>   create mode 100644 include/linux/ti-usim.h
>> Any comments on this patch series ?
>>
>> If not,
>> Can you accept these patches for next merge window
> It's the middle of this merge window, and I can't accept any patches
> until after 3.14-rc1 is out, at which point I'll start to work on my
> patch backlog.
Are these to be consider for next submission ? Or you want me to start 
review cycle one more time.
> thanks,
>
> greg k-h