[PATCH v2 2/3] drm/panel: add support for EDT panels

[Stefan Agner]

Am 2014-05-15 11:08, schrieb Thierry Reding:
> On Thu, May 15, 2014 at 10:27:29AM +0200, Philipp Zabel wrote:
>> The ETM0700G0DH6 Datasheet lists 2 lines as the typical vsync pulse
>> width, 525 lines as the vertical period, and 35 lines as the vsync -de
>> time, which is vsync len + back porch.
>> So vertical timings 480 + 10 + 2 + 33 = 525 should be valid for the
>> ET0700G0DH6 panel:
> 
> Shouldn't that work with 480 + 8 + 2 + 35 too? It seems to me that it
> should still be safe for that panel. Similarily I'd expect your timings
> to work on the ET070080DH6.

Am 2014-05-15 11:12, schrieb Thierry Reding:
> Okay, so that means that the panel works for you with the same timings
> that Philipp has in the ETM0700G0DH6 patch? If so then I definitely
> think we should be sharing the timings in the driver by making the two
> compatible entries point to the same driver data.

FWIW, I checked and it works with both timings. And I bet it is really
the same panel its just a different touch on top.

> Irrespective of that they both seem to have different capabilities so
> two compatible values should be fine. However for the purpose of the
> simple panel driver they could be made to share the same timings if it
> works for both panels and devices.
> 
> As for the touch panel on the ETM0700G0DH6, do you happen to know how
> that's usually connected? I suspect it needs external hardware to
> capture the YU, XL, YD and XR pins and turn that into raw coordinates
> and pen down interrupts.

For Colibri Evaluation Board, those pins are routed to the generic
4-wire pins of the Colibri SO-DIMM. On the Colibri T30 module, those
pins are connected to a STMPE811. I also added that to the device tree
once, however it does not work properly atm, I need to debug this and
will send a patch at a later time.

--
Stefan