[PATCH v4 5/5] ARM: dts: enable hdmi for exynos5800 based peach-pi board

[Tomasz Figa]

Hi Rahul,

On 14.05.2014 04:46, Rahul Sharma wrote:
> From: Rahul Sharma <Rahul.Sharma at samsung.com>
> 
> Enable hdmi for peach-pi board.
> 
> Signed-off-by: Rahul Sharma <Rahul.Sharma at samsung.com>
> ---
>  arch/arm/boot/dts/exynos5800-peach-pi.dts |   19 +++++++++++++++++++
>  1 file changed, 19 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/exynos5800-peach-pi.dts b/arch/arm/boot/dts/exynos5800-peach-pi.dts
> index 742655b..2a6f23b8 100644
> --- a/arch/arm/boot/dts/exynos5800-peach-pi.dts
> +++ b/arch/arm/boot/dts/exynos5800-peach-pi.dts
> @@ -134,6 +134,25 @@
>  	};
>  };
>  
> +&i2c_2 {
> +	status = "okay";
> +	samsung,i2c-sda-delay = <100>;
> +	samsung,i2c-max-bus-freq = <66000>;
> +	samsung,i2c-slave-addr = <0x50>;
> +
> +	hdmiddc at 50 {
> +		reg = <0x50>;
> +	};
> +};
> +
> +&hdmi {
> +	status = "okay";
> +	hpd-gpio = <&gpx3 7 2>;

What is the 2 flag? I don't see any value other than 0 and 1 defined in
include/dt-bindings/gpio/gpio.h. Also it would be better to use
preprocessor macros instead of magic numbers for flags like this.

Best regards,
Tomasz