[PATCH 1/2] ARM: dts: Enable USB 3503 hub on exynos5250-snow

[Tomasz Figa]

On 08.05.2014 17:59, Andreas Färber wrote:
> Hello,
> 
> Am 05.05.2014 14:30, schrieb Vivek Gautam:
>> The exynos5250-snow has a SMSC USB3503 connected in
>> hardware only mode like a PHY. Enable support for it,
>> and add necessary 'reset-gpio' for it.
>>
>> This is in correspondance to similar patch by Mark Brown
>> 7c1b0ec ARM: dts: Enable USB hub on Arndale
>>
>> Signed-off-by: Vivek Gautam <gautam.vivek at samsung.com>
>> ---
>>
>> Based on 'for-next' branch of kgene's linux-samsung tree.
>>
>>  arch/arm/boot/dts/exynos5250-pinctrl.dtsi |    7 +++++++
>>  arch/arm/boot/dts/exynos5250-snow.dts     |   14 ++++++++++++++
>>  2 files changed, 21 insertions(+)
> 
> The same snippet as for snow also fixed my USB issues on spring.
> Should it go into exynos5250-cros-common.dtsi instead?

The GPIO pins used are different, so I don't think the hub node added by
these patches could be shared.

Also, I believe all you need to add is a simple node as follows

usb_hub {
	compatible = "smsc,usb3503a";
	reset-gpios = <&gpe1 0 1>;
};

at root level (see my comments to this patch in another reply), which is
affordable to be duplicated for every platform that requires it,
especially if the reset-gpios property differs between boards.

Best regards,
Tomasz