[PATCHv4 02/20] usb: ehci-orion: rename error goto labels in ehci_orion_drv_probe()

Thomas Petazzoni thomas.petazzoni at free-electrons.com
Wed May 7 06:52:08 PDT 2014


In preparation to the introduction of additional initialization steps
in ehci_orion_drv_probe(), we rename the error goto labels from err1,
err2 and err3 names to some more meaningful names.

Signed-off-by: Thomas Petazzoni <thomas.petazzoni at free-electrons.com>
---
 drivers/usb/host/ehci-orion.c | 18 +++++++++---------
 1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/drivers/usb/host/ehci-orion.c b/drivers/usb/host/ehci-orion.c
index 7728e83..9298be7 100644
--- a/drivers/usb/host/ehci-orion.c
+++ b/drivers/usb/host/ehci-orion.c
@@ -160,7 +160,7 @@ static int ehci_orion_drv_probe(struct platform_device *pdev)
 			"Found HC with no IRQ. Check %s setup!\n",
 			dev_name(&pdev->dev));
 		err = -ENODEV;
-		goto err1;
+		goto err;
 	}
 
 	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
@@ -169,7 +169,7 @@ static int ehci_orion_drv_probe(struct platform_device *pdev)
 			"Found HC with no register addr. Check %s setup!\n",
 			dev_name(&pdev->dev));
 		err = -ENODEV;
-		goto err1;
+		goto err;
 	}
 
 	/*
@@ -179,12 +179,12 @@ static int ehci_orion_drv_probe(struct platform_device *pdev)
 	 */
 	err = dma_coerce_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32));
 	if (err)
-		goto err1;
+		goto err;
 
 	regs = devm_ioremap_resource(&pdev->dev, res);
 	if (IS_ERR(regs)) {
 		err = PTR_ERR(regs);
-		goto err1;
+		goto err;
 	}
 
 	/* Not all platforms can gate the clock, so it is not
@@ -197,7 +197,7 @@ static int ehci_orion_drv_probe(struct platform_device *pdev)
 			&pdev->dev, dev_name(&pdev->dev));
 	if (!hcd) {
 		err = -ENOMEM;
-		goto err2;
+		goto err_create_hcd;
 	}
 
 	hcd->rsrc_start = res->start;
@@ -237,17 +237,17 @@ static int ehci_orion_drv_probe(struct platform_device *pdev)
 
 	err = usb_add_hcd(hcd, irq, IRQF_SHARED);
 	if (err)
-		goto err3;
+		goto err_add_hcd;
 
 	device_wakeup_enable(hcd->self.controller);
 	return 0;
 
-err3:
+err_add_hcd:
 	usb_put_hcd(hcd);
-err2:
+err_create_hcd:
 	if (!IS_ERR(clk))
 		clk_disable_unprepare(clk);
-err1:
+err:
 	dev_err(&pdev->dev, "init %s fail, %d\n",
 		dev_name(&pdev->dev), err);
 
-- 
1.9.2




More information about the linux-arm-kernel mailing list