[PATCH V2 05/19] mmc: mmci: Add DT bindings for feedback clock pin

[Ulf Hansson]

The ST Micro variant supports the option of using a feedback clock signal in
favor of the clockout pin when latching incoming signals on the data bus.

Since this is matter of how pins are being routed we need to provide a new DT
binding to be able to configure this through DT.

Signed-off-by: Ulf Hansson <ulf.hansson at linaro.org>
---
 Documentation/devicetree/bindings/mmc/mmci.txt |    2 ++
 drivers/mmc/host/mmci.c                        |    2 ++
 2 files changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/mmc/mmci.txt b/Documentation/devicetree/bindings/mmc/mmci.txt
index 9bd2ffa..2c8756f 100644
--- a/Documentation/devicetree/bindings/mmc/mmci.txt
+++ b/Documentation/devicetree/bindings/mmc/mmci.txt
@@ -24,6 +24,7 @@ Optional properties:
 - st,sig-dir-dat31       : bus signal direction pin used for DAT[3] and DAT[1].
 - st,sig-dir-dat74       : bus signal direction pin used for DAT[4] to DAT[7].
 - st,sig-dir-cmd         : cmd signal direction pin used for CMD.
+- st,sig-pin-fbclk       : feedback clock signal pin used.
 
 Example:
 
@@ -47,6 +48,7 @@ sdi0_per1 at 80126000 {
 	st,sig-dir-dat0;
 	st,sig-dir-dat2;
 	st,sig-dir-cmd;
+	st,sig-pin-fbclk;
 
 	vmmc-supply = <&ab8500_ldo_aux3_reg>;
 	vqmmc-supply = <&vmmci>;
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index c99ec88..3663bc15 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -1402,6 +1402,8 @@ static void mmci_dt_populate_generic_pdata(struct device_node *np,
 		pdata->sigdir |= MCI_ST_DATA74DIREN;
 	if (of_get_property(np, "st,sig-dir-cmd", NULL))
 		pdata->sigdir |= MCI_ST_CMDDIREN;
+	if (of_get_property(np, "st,sig-pin-fbclk", NULL))
+		pdata->sigdir |= MCI_ST_FBCLKEN;
 
 	pdata->gpio_wp = of_get_named_gpio(np, "wp-gpios", 0);
 	pdata->gpio_cd = of_get_named_gpio(np, "cd-gpios", 0);
-- 
1.7.9.5