[PATCH V2 01/19] mmc: mmci: Convert to the mmc gpio API
Ulf Hansson
ulf.hansson at linaro.org
Mon Mar 31 11:18:02 EDT 2014
To avoid duplication of code while handling card detect and write
protect GPIO pins/irqs, let's convert to use the mmc gpio API.
Signed-off-by: Ulf Hansson <ulf.hansson at linaro.org>
---
drivers/mmc/host/mmci.c | 97 ++++++++---------------------------------------
drivers/mmc/host/mmci.h | 3 --
2 files changed, 15 insertions(+), 85 deletions(-)
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index 771c60a..b0b81ac 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -23,6 +23,7 @@
#include <linux/mmc/pm.h>
#include <linux/mmc/host.h>
#include <linux/mmc/card.h>
+#include <linux/mmc/slot-gpio.h>
#include <linux/amba/bus.h>
#include <linux/clk.h>
#include <linux/scatterlist.h>
@@ -1326,35 +1327,18 @@ static void mmci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
pm_runtime_put_autosuspend(mmc_dev(mmc));
}
-static int mmci_get_ro(struct mmc_host *mmc)
-{
- struct mmci_host *host = mmc_priv(mmc);
-
- if (host->gpio_wp == -ENOSYS)
- return -ENOSYS;
-
- return gpio_get_value_cansleep(host->gpio_wp);
-}
-
static int mmci_get_cd(struct mmc_host *mmc)
{
struct mmci_host *host = mmc_priv(mmc);
struct mmci_platform_data *plat = host->plat;
- unsigned int status;
+ unsigned int status = mmc_gpio_get_cd(mmc);
- if (host->gpio_cd == -ENOSYS) {
+ if (status == -ENOSYS) {
if (!plat->status)
return 1; /* Assume always present */
status = plat->status(mmc_dev(host->mmc));
- } else
- status = !!gpio_get_value_cansleep(host->gpio_cd)
- ^ plat->cd_invert;
-
- /*
- * Use positive logic throughout - status is zero for no card,
- * non-zero for card inserted.
- */
+ }
return status;
}
@@ -1391,21 +1375,12 @@ static int mmci_sig_volt_switch(struct mmc_host *mmc, struct mmc_ios *ios)
return ret;
}
-static irqreturn_t mmci_cd_irq(int irq, void *dev_id)
-{
- struct mmci_host *host = dev_id;
-
- mmc_detect_change(host->mmc, msecs_to_jiffies(500));
-
- return IRQ_HANDLED;
-}
-
static struct mmc_host_ops mmci_ops = {
.request = mmci_request,
.pre_req = mmci_pre_request,
.post_req = mmci_post_request,
.set_ios = mmci_set_ios,
- .get_ro = mmci_get_ro,
+ .get_ro = mmc_gpio_get_ro,
.get_cd = mmci_get_cd,
.start_signal_voltage_switch = mmci_sig_volt_switch,
};
@@ -1494,10 +1469,6 @@ static int mmci_probe(struct amba_device *dev,
host = mmc_priv(mmc);
host->mmc = mmc;
- host->gpio_wp = -ENOSYS;
- host->gpio_cd = -ENOSYS;
- host->gpio_cd_irq = -1;
-
host->hw_designer = amba_manf(dev);
host->hw_revision = amba_rev(dev);
dev_dbg(mmc_dev(mmc), "designer ID = 0x%02x\n", host->hw_designer);
@@ -1568,6 +1539,9 @@ static int mmci_probe(struct amba_device *dev,
mmc->caps = plat->capabilities;
mmc->caps2 = plat->capabilities2;
+ if (!plat->cd_invert)
+ mmc->caps2 |= MMC_CAP2_CD_ACTIVE_HIGH;
+ mmc->caps2 |= MMC_CAP2_RO_ACTIVE_HIGH;
if (variant->busy_detect) {
mmci_ops.card_busy = mmci_card_busy;
@@ -1621,49 +1595,23 @@ static int mmci_probe(struct amba_device *dev,
goto err_gpio_cd;
}
if (gpio_is_valid(plat->gpio_cd)) {
- ret = gpio_request(plat->gpio_cd, DRIVER_NAME " (cd)");
- if (ret == 0)
- ret = gpio_direction_input(plat->gpio_cd);
- if (ret == 0)
- host->gpio_cd = plat->gpio_cd;
- else if (ret != -ENOSYS)
+ ret = mmc_gpio_request_cd(mmc, plat->gpio_cd, 0);
+ if (ret)
goto err_gpio_cd;
-
- /*
- * A gpio pin that will detect cards when inserted and removed
- * will most likely want to trigger on the edges if it is
- * 0 when ejected and 1 when inserted (or mutatis mutandis
- * for the inverted case) so we request triggers on both
- * edges.
- */
- ret = request_any_context_irq(gpio_to_irq(plat->gpio_cd),
- mmci_cd_irq,
- IRQF_TRIGGER_RISING | IRQF_TRIGGER_FALLING,
- DRIVER_NAME " (cd)", host);
- if (ret >= 0)
- host->gpio_cd_irq = gpio_to_irq(plat->gpio_cd);
}
if (plat->gpio_wp == -EPROBE_DEFER) {
ret = -EPROBE_DEFER;
- goto err_gpio_wp;
+ goto err_gpio_cd;
}
if (gpio_is_valid(plat->gpio_wp)) {
- ret = gpio_request(plat->gpio_wp, DRIVER_NAME " (wp)");
- if (ret == 0)
- ret = gpio_direction_input(plat->gpio_wp);
- if (ret == 0)
- host->gpio_wp = plat->gpio_wp;
- else if (ret != -ENOSYS)
- goto err_gpio_wp;
+ ret = mmc_gpio_request_ro(mmc, plat->gpio_wp);
+ if (ret)
+ goto err_gpio_cd;
}
- if ((host->plat->status || host->gpio_cd != -ENOSYS)
- && host->gpio_cd_irq < 0)
- mmc->caps |= MMC_CAP_NEEDS_POLL;
-
ret = request_irq(dev->irq[0], mmci_irq, IRQF_SHARED, DRIVER_NAME " (cmd)", host);
if (ret)
- goto unmap;
+ goto err_gpio_cd;
if (!dev->irq[1])
host->singleirq = true;
@@ -1695,14 +1643,6 @@ static int mmci_probe(struct amba_device *dev,
irq0_free:
free_irq(dev->irq[0], host);
- unmap:
- if (host->gpio_wp != -ENOSYS)
- gpio_free(host->gpio_wp);
- err_gpio_wp:
- if (host->gpio_cd_irq >= 0)
- free_irq(host->gpio_cd_irq, host);
- if (host->gpio_cd != -ENOSYS)
- gpio_free(host->gpio_cd);
err_gpio_cd:
iounmap(host->base);
clk_disable:
@@ -1741,13 +1681,6 @@ static int mmci_remove(struct amba_device *dev)
if (!host->singleirq)
free_irq(dev->irq[1], host);
- if (host->gpio_wp != -ENOSYS)
- gpio_free(host->gpio_wp);
- if (host->gpio_cd_irq >= 0)
- free_irq(host->gpio_cd_irq, host);
- if (host->gpio_cd != -ENOSYS)
- gpio_free(host->gpio_cd);
-
iounmap(host->base);
clk_disable_unprepare(host->clk);
diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h
index 58b1b88..8fc5814 100644
--- a/drivers/mmc/host/mmci.h
+++ b/drivers/mmc/host/mmci.h
@@ -176,9 +176,6 @@ struct mmci_host {
struct mmc_data *data;
struct mmc_host *mmc;
struct clk *clk;
- int gpio_cd;
- int gpio_wp;
- int gpio_cd_irq;
bool singleirq;
spinlock_t lock;
--
1.7.9.5
More information about the linux-arm-kernel
mailing list