[PATCHv2 1/1] mtd: gpmi: make blockmark swapping optional

Lothar Waßmann LW at KARO-electronics.de
Fri Mar 28 05:01:58 EDT 2014


Hi,

Huang Shijie wrote:
> 于 2014年03月28日 16:16, Lothar Waßmann 写道:
> > Still there is no need for the Linux NAND driver to be able to read or
> > write partitions in a format that the Boot ROM can understand. Thus it
> If you do not use the NAND boot, there really no need to do so.
>
There is no need for the ROM code to access any other partition than
the bootloader itself. Thus Linux can perfectly well be booted from
NAND without any byte swapping.

> Since you need the NAND boot, we should enable the swapping for imx28.
>
Why? There is no need for Linux to do any swapping when not accessing
the bootloader partition.

> > is perfectly legal to allow disregarding the BB marks and solely rely on
> > a flash based BBT.
> >
> The BB mark is in the page 0 of a NAND block. But the swapping can occur 
> in _each_ page of
> a NAND block, _NOT_ only the page 0.
> 
> I think you are confusing at these two things.
> 
No, I'm not confusing anything. The swapping in any other page than
page 0 is completely useless. Thus, when there is no need to recognize
the BB markers, there in no need to do any swapping too.


Lothar Waßmann
-- 
___________________________________________________________

Ka-Ro electronics GmbH | Pascalstraße 22 | D - 52076 Aachen
Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10
Geschäftsführer: Matthias Kaussen
Handelsregistereintrag: Amtsgericht Aachen, HRB 4996

www.karo-electronics.de | info at karo-electronics.de
___________________________________________________________



More information about the linux-arm-kernel mailing list